Manual FlashLED Li-Ion –Basic information
Page 9/17
GIFAS-ELECTRIC GmbH · Dietrichstrasse 2 · CH-9424 Rheineck · Phone +41 71 886 44 44 · Fax +41 71 886 44 49 · info@gifas.ch
1.7 Responsibilities of the operator
1. Ensure that this document is always stored together with the device.
2. Carefully read this manual before putting the device into operation for the first time.
3. This product has been designed and produced exclusively for the use specified in the documents. Any other
use that is not expressly stated could affect the integrity of the product and/or represent a source of danger.
4. The manufacturer assumes no liability for damage caused by improper use or usage not according to the
intended use of the product.
5. The product must not be used in environments where there is a risk of explosion. Flammable gases or
smoke constitute a serious safety risk.
6. In addition to Swiss regulations, the standards and regulations applicable in the country of use must be
observed.
7. Installation must be performed in accordance with the valid regulations.
8. The manufacturer accepts no liability in the event of improper installation or in the case of deformation that
may occur during use.
9. Before carrying out any work on the device, the power supply must be switched off.
10. During servicing, only original manufacturer’s parts may be used. Servicing work on the FlashLED light may
only be performed by qualified personnel.
11. Any procedure not expressly mentioned by the manufacturer in the instructions is not permitted.
12. Installation of the charging station must be performed in accordance with the valid regulations.
13. The packaging materials (plastic, polystyrene, etc.) should not be stored within reach of children.
Although the FlashLED lamp has been designed for harsh environments, it must be ensured
that it is used according to the IP65 protection standard to prevent damage and
malfunctions.
It should also be ensured that the loading station of the FlashLED lamp is operated in a
dry place according to its protection standard (IP20).
1.8 Start-up
The FlashLED is set to energy-saving mode upon delivery. The main operating electronics
are switched off, only the monitoring feature for the li-ion battery is activated.
To start-up please insert the lamp into the charging station and charge the battery
completely.
1.9 Storage/transport
The light can be stored for no more than one year with the factory charge (delivery state).
After more than one year, the battery must be re-charged.
Store batteries at room temperatures between 10° and 20° C.
Always protect the battery from temperatures below 0° C and above 45° C (e.g. continuous sun exposure),
fire, water and moisture.
The original packaging protects the lamp from damage.
To avoid short circuits, cover the charging contacts when the product is not in use.
Do not place highly flammable material in the vicinity of the lamp or the charger.
The lamp should only be transported using the handles provided.
