GIMBAL CAPTURE Manuale utente
V2.0
1、产品概览 Product Overview
俯仰轴 Pitch
横滚 Roll
航向 Yaw
USB充电口 Charging Port
方向控制键 Joystick
电源/模式键（内置指示灯）
Power,Mode Button(indicator LED
)
航向轴电机 Pan Motor
拍照录像键
Photo/Recording Button
俯仰轴电机 Tilt Motor
横滚轴电机
Roll Motor
2、配件 Accessories
配重块
Couterweight
USB充电线
USB Charging Cable
18650 2600mAh可充电电池
18650 2600mAh Rechargeable Battery
3、入门指南 Start Guide
（1）为电池充电
Charge the Battery
a. 将USB 线的 Mini-USB端插入稳定器的USB 端口里面，另一USB 端口
连接电源适配器。（适配器需要自备）
Plug the charging cable into gimbal charing port, then connect the
cable with power adaptor. ( Power adptor is not included)
b. 充电过程中，稳定器手柄后侧的指示灯慢闪，充满后指示灯常亮，充电
大概需要2小时。
During the charging, the indicator behind the holder blinks. If the
battery is full charged, the indicator is solid light. The charging time
is about 2 hours.
（2）调平与开机
Balance the Phone and Switch on
a. 按照图示箭头方向，用力拉开手机夹持件，将手机平移进去，确保手机
可以紧紧的夹持住。
As shown in the picture, pull the phone hold vigorously, and then
move the phone into the hold. Make sure your phone is hold tightly.
注意：安装前请取下手机保护壳
Noted:Please remove the phone protection before use.
b. 装上配重块或者左右移动手机，确保手机左右基本平衡。（根据手机尺
寸选择是否需安装配重块，4.7寸以下手机无需安装配重块，4.7寸以上手
机则需安装配重块）
Install counterweight or move your phone left or right at proper
position to keep the phone almost balance.
c. 开机。先短按一次电源键，再长按电源键保持 3 秒开启云台（长按电源
键 3 秒即可关机，开关机时会听到嘀的一声长响）
Turn on the power. Short press the power button one time, then
press it again for 3 seconds, the gimbal will start to work. (Long
press the power button 3 seconds, it will turn off. There is one beep
when turn on or turn off the gimbal. )
注意：通电前务必确保您的手机已经夹紧并且左右基本平衡。
Noted: Make sure your phone is hold tightly and almost balance
before turn on the power.
平衡线 Reference Line 配重块
Counter
weight
a.
b.将手机装上后调平，然后开机。
Install the phone on the gimbal and keep it balance ,then turn on the
power.
c.先打开手机蓝牙，再打开app, 点击蓝牙搜索按钮，选择“Phone Gimbal”
的蓝牙设备，点击连接。 注意：必须在APP里面连接蓝牙。
Turn on phone bluetooth, and then open the app, click bluetooth
searching button. Choose “ Phone Gimbal” device for connection.
Attention：bluetooth only permitted connected in APP.
Start
r
2
2
d.
Shoot interface function shows as below.
注意：
and
设置
Setting
相册
Album
追踪
Tracking
拍摄
Take Photos
蓝牙连接
Bluetooth Connecting
拍摄转换
Shooting Switch
拍摄设置
Shooting Setting
相机切换
Camera Switch
滤镜
Filter
专业模式
Professional Mode
美颜
Beautification
云台开机后，打开手机蓝牙设置，搜索“photoshutter”的蓝牙设备，点击连接。
然后打开手机自带的相机，云台的拍摄键可以作为相机的快门键使用。
Turn on the gimbal, open phone bluetooth setting, search”photoshutter”
device, click for connection. Then, you can use the shooting button to
control original camera take photo or video.
shooting mode.
使用运动相机转接板，可以兼容Gopro 4/5/6/7及同尺寸的运动相机。
With extra adapter to be compatible with Gopro 4/5/6/7 and the same
size action camera.
(4) 蓝牙控制手机自带相机拍照
Bluetooth Controls Phone’s Original Camera to Take Phones
r
fter
switch on
Y
Solid light
Y
Mode
Click 3 times
闪烁3次
rtical Shooting ds leftside to enter
ds
tical shooting
长按3秒
Long press for 3
Seconds
关机
Swit
Indice
