5
If signal on the amp loop is too low the switches should be set like on the
picture below.
Attenuation and boost module settings
Attenuation and boost controls are placed on the front panel of the ALA-1.
They can be set by using small flat screwdriver.
If the effect features gain or peak indicator setting should be started either
from the ATTENUATION module (if order switches are set to AT/BO) or from
BOOST module (if order switches are set to BO/AT). For maximal utility
signal (very often it is a clean tone) the regulator should be set to maximal
value on which the peak indicator doesn’t light. After, the BOOST control
(for order AT/BO) or ATTENUATION control (for order BO/AT) should be set
to similar dB value in order to retain the signal level.
If the effect doesn’t feature gain or peak indicator both controls should be set
to minimum. Further, the signal level passing to the effect should be boosted
either with ATTENUATION module control (for order AT/BO) or BOOST
module control (for order BO/AT) up to the maximal value on which the signal
overdrive doesn’t appear. After, the BOOST control (for order AT/BO) or
ATTENUATION control (for order BO/AT) should be set to similar dB value in
order to retain the signal level.
