Glider.it Diana 3 Istruzioni per l’uso
www.glider-it.com
Construction manual
-Place a pad on your workbench to protect the surface of your model
- Then you can start with the removal of the wings. In the example
shown here, K T – X10 are installed on the flaps and on the inner
ailerons. K T - H 08A are used on the outer ailerons. Prepare the servo
frames and grind them thoroughly at the bottom and on the side edges.
This is the only way to ensure a proper adhesive bond.
- Next, they glue a frame made of crepe tape around the servo shafts.
This is for protection and is needed to mark the exact positions of the
servo frames.
- The edges of the servo bay can be slightly reduced. Original have this
6mm width. If you shorten this to half, it makes it easier to install the
servo frames
- The recesses for the rudder horns are already prepared as standard.
These are used for orientation and the position of the servo frame is
marked. With the help of a geotriangle, a line (90 degrees to the hinge) is
drawn
In the outer ailerons, the rudder horns come to the bottom (classic
linkage) and there the position can be transmitted directly
-On the flaps and the inner ailerons, the rudder horns come to the top
(crossover linkage) and there the position must first be transferred from
the top to the bottom.
-To do this, as explained above, they draw a line at a 90-degree angle to
the hinge. tarting from the recess for the rowing horn.
- They draw this line to the end bar and then transfer the position to the
lower shell
From this point, in 90 degrees to the hinge, you can then draw the
required lines
- Next, roughen the surface in the servo shaft and then all adhesive
surfaces (servo bay and servo frame) are degreased
In the next step, the servo frames are prepared for gluing.
There are 2 possibilities: Either they wet the servos with release wax or
they wrap them in cling film. If this is not done carefully, you will not get
the servos removed later because they are firmly glued.
- Now all servos are screwed into their frames.
Important: With servo arm, fork head and a linkage (the length of the
linkage does not matter here)
The rear crossbar on the X10 can be omitted. The servo is fixed at 3
points (2 screws + the counter bearing) and this is sufficient
- Now the 6 servo frames can be glued in. For this they either use Uhu
Endfest or you mix a mumble of 24h resin with cotton flakes and some
thixotropic agent.
If your glue is ready, wet the places in the servo bay and the servo
frames with the glue with a brush. Place the servo frames in the desired
position and align it cleanly with the help of the previously drawn lines.
- After everything is in it, the position is checked again and the whole
thing is weighed down a little.
For this you can use small cups with 100g - 200g lead in each
- Once the whole thing has hardened, the ribs of the counter bearings
are glued to the lower shell.
For this again use an adhesive or mummy. It is important that this must
be touched very toughly, it must no longer flow. Pull the glue into a small
syringe. This makes it easy to bring the adhesive to the desired position.
- It is important here that no glue comes to the ball bearing
- When everything has hardened, the installation of the rowing horns
continues
Before the rudder horns can be positioned, the prefabricated cut-outs
must be reworked a little
Altri manuali Glider.it Aereo
