GMC GMCAB18 Manuale utente

GMC EVAPORATIVE AIR COOLER

TECHNICAL MANUAL

Thank you for your choice of GMC evaporative air cooler.

This manual provides you with information of GMC evaporative air cooler technical data, wire

diagram, installation, operation, maintenance and troubleshooting. Please read this manual

carefully before operation.

We believe that cooling and fresh air of GMC evaporative air cooler will bring you with comfort

and health.

GMC EVAPORATIVEAIR COOLER –IMPORTANT NOTES

1- After turning on the cooler, be sure that water pump should work for 3 minutes first, let water

evenly distributed onto cooling pads, then start fan and adjust fan speed. This step is very

important to prevent water drop from splashing on motor and helpful to prolong motor

lifespan.

2- Ensure the single-phase voltage is ± 5%. Too low or high voltage may cause damage to

cooler.

3- Before running cooler, please fill water tank with water, otherwise, cooler can not work

properly or even cause damage to water pump.

4- Do not use cooler inside an enclosed space; the places must be sufficiently ventilated.

GMC EVAPORATIVEAIR COOLER –

TECHNICAL DATA

Technical data of GMC EvaporativeAir CoolerAB18 Variable speed

Motor

Single-phase

Six-speed

Variable-frequency

motor

Effective space

120-150M2

Power supply 220V 50 Hz

Water supply 20-30L/H

Motor power 0.55-1.1 KW

Air outlet size

670 mm × 670 mm

Fan type Axial

Net Weight 58 kg

Pump type

submersible Gross Weight 68 kg

Fan size

590 mm Dimension 1070mm×1070mm×1090mm

Airflow 900-18000M3/H

Air outlet size 670 mm × 670 mm

Wire 3 M Control system LCD display

GMC EVAPORATIVE AIR COOLER –INSTALLATION TIPS

1-The supporting frame must be strong and firm enough to bear the weight of cooler and

maintenance technician.

2-The cooler installation must be horizontal, not acclivitous, otherwise, water will overflow from

the cooler water sump.

3- Ensure that drainage elbow is installed properly; keep it from cooler duct to avoid the water

drops go into the duct when it is windy.

4-The cooler should be installed at least 3 M away from the vicinity. Provide a minimum of 1 M

of clearance to any side of the cooler that requires access for maintenance.

GMC EVAPORATIVE AIR COOLER –USE INSTRUCTION OF SINGLE

PHASE, 6- SPEED VARIABLE

1- ON/OFF

When the power is on, press ON/OFF to start or stop the machine.

2- MODE

Press MODE to choose three operation modes: COOL, FAN or DRAIN.

COOL: I is the cooling figure. The water pump will run for three minutes first, water is

evenly distributed onto cooling pads, and then the fan starts. Press ▲▼to adjust airflow from 1-6.

FAN: is the fan figure. At this moment, the water pump does not work, only fan delivers

airflow. Press ▲▼to adjust speed from 1-6.

DRAIN: is the drain figure. When draining, the arrowhead runs.

3- TIME SETTING

Press TIME for the first time, you can set time of cooler start, adjust its starting time by pressing

▲▼; Press TIME for the second time, you can set time of cooler stopping, adjust its stopping

time by pressing ▲▼. Press TIME until the number flickers for three seconds, the time setting of

cooler starting and stopping is cancelled.

4- CLOCK

CLOCK is for clock setting. Adjust clock by pressing ▲▼.

5- SWING

Not used.

GMC EVAPORATIVE AIR COOLER – MAINTENANCE

1- If the cooler is used in very sandy and dusty areas, cooling pads should be often cleaned to

ensure cooling efficiency. When cleaning, do not use high pressure water, hot water (up to 40 ℃)

or chemical detergents.

2- Clean cooler water sump every half year to keep the cooling air clean and fresh.

3- Drain the water from water sump after the first 24 hours of new cooler operation, the odor will

not smell any more.

4- To prevent the cooler freezing and worms, do shut up water supply and keep the water sump

dry if the cooler will be leaved unused for a long time. Cover it in sandy or snowy weather if

necessary.

5- Make sure that all the cooler screws are not loose to prevent cooler from shaking severely when

its operation.

GMC EVAPORATIVE AIR COOLER –TROUBLESHOOTING

Malfunction Check Solution

No menu on LCD

panel

( only for LCD cooler)

1. Check if cooler is energized.

2. Check if signal wire connection is correct.

3. Check if main control board goes wrong.

1. Plug again and ensure power supply

2. Turn off and re-connect signal wire.

3. Replace main control board or fuse.

2 LCD is out of control

( only for LCD cooler)

1. Check if LCD main control board is burned up. 1. Replace main control board.

2. Replace display panel.

3 Blurry display

( only for LCD cooler)

1. Open controller bottom cover and check if circuit board is

dusty and/or contaminated.

2. Open controller bottom cover and check if circuit board is wet.

1. Clear off dust.

2. Properly blow off moisture.

“Er” displayed on

control panel

( only for LCD cooler)

1. Check if temperature sensor has problem. 1. Replace temperature sensor.

Cooler stops

automatically after 20

min when cooling

( only for LCD cooler)

1. Check if water level is too low.

1. Increase water pipe pressure.

2. Adjust float valve, make water level 7-10

CM high.

3. Replace water inlet valve.

6 Fan fails to deliver

airflow

1. Check if motor is damaged.

2. Check if fan blades are stuck.

3. Check if LCD main control board is damaged.

1. Replace motor.

2. Adjust fan blades position.

3. Replace contactor.

4. Replace capacitor.

5. Replace LCD main control board.

7 Cooler fails to deliver

cooling air flow

1. Check if there is water in the sump.

2. Check if the water level is too low.

3. Check if pump is in good condition.

1. Increase water pipe pressure.

2. Adjust float valve, make water level 7-10

CM high.

3. Ensure pump wire is connected.

4. Clean pump.

5. Replace pump.

8 Small airflow delivery

1. Check if there is impurity in cooling pads.

1. Clean cooling pads with normal city

water; do not use high pressure water

and any chemical detergent.

9 Drainage valve leaks

1. Check if there is too much impurity in water sump.

2. Check if water level is too high in water sump.

3. Check if drainage valve rubber ring is in good condition.

4. Check if pump is damaged.

1. Clean water sump.

2. Make water level 7-10 CM high.

3. Replace valve rubber ring.

4. Replace pump.

GMC EVAPORATIVEAIR COOLER –FAULT CODE

Water overflow from

cooler

1. Check if water level is too high in water sump.

2. Check if cooler is installed horizontally.

3. Check if sealing ring of float valve is in good condition.

4. Check if float valve is damaged.

1. Adjust float valve and make water level

7-10 CM high.

2. Adjust cooler installation horizontally.

3. Replace sealing ring of float valve.

4. Replace float valve.

Water drops splash

from cooler

1. Check if inner water pipes fall from joints.

2. Check if elbows fall from joints.

3. Check if cooling pads are blocked.

1. Fix inner water pipes again.

2. Fix elbows again.

3. Clean cooling pads.

Water drops splash

from duct 1. Check if drainage outlet is installed properly. 1. Extend drainage outlet length with pipe.

Violent vibration

when operation

1. Check if screws are loose.

2. Check if fan blades deform.

1. Fix screws.

2. Replace fan blades.

Altri manuali GMC Condizionatore d'aria

GMC

GMC AB20 Manuale utente

GMC

GMC GMCAB50 Manuale utente

Manuali Condizionatore d'aria popolari di altre marche

Spheros

Spheros CC 355 Manuale utente

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manuale utente

Panasonic

Panasonic CS-E12HKEW Manuale utente

nedis

nedis ACMB1WT7 Manuale utente

Samsung

Samsung AR KV Series Guida

Daikin

Daikin FCFV50A Manuale utente

Fujitsu

Fujitsu Inverter ASBA30JFC Manuale utente

Toshiba

Toshiba RAS-M10SMUV-E Manuale utente

Daikin

Daikin FXLQ20MAVE Manuale utente

Hitachi

Hitachi RAS-E24CAK Manuale utente

CIAT

CIAT Magister 2 Series Guida

Bestron

Bestron AAC6000 Manuale utente

Hisense

Hisense 7K Manuale tecnico

Frigidaire

Frigidaire FFRE0533S1E0 Manuale utente

Samsung

Samsung AS09HM3N Manuale utente

Frigidaire

Frigidaire CRA073PU11 Manuale del proprietario

Soleus Air

Soleus Air GB-PAC-08E4 Manuale utente

McQuay

McQuay MCK020A Manuale utente