GMT Xcluder Series Manuale utente
750 W Lake Cook Rd, Suite 480 | Buffalo Grove, IL 60089 | Ph: 847.495.4700
w w w . G e t X c l u d e r . c o m
Installation Instructions:
1. Sweep should be mounted on the outside of the door.
2. Measure door and cut sweep to fit. This step may not be necessary. If
cutting is required, cut excess material from the end of the sweep that does
not have the pre-installed guards.
3. When cutting the sweep, best results are obtained by first using a hacksaw
to cut through the aluminum retainer and then sturdy shears to cut the
rubber and Xcluder filling. NOTE: Sawing through the Xcluder filling is not
recommended.
4. Using the end of the sweep with the metal end guards already installed as a
model, install the end guards on the opposite end of the sweep, as follows:
a. Using a standard screwdriver, gently separate Xcluder filling from
the metal mesh in a ½” wide x ¾” deep section at the middle of both
faces on the sweep.
b. Place an end clip on it’s side on a hard, flat, sturdy surface.
c. Hold the end guard and drive the standard screwdriver blade into
the end guard at the looped end. This will separate the open end.
d. Place the opened end guard, flat side out, onto one of the edges of
the door sweep in the location the Xcluder filling was separated from
the metal mesh.
e. Holding the end guard in place with your thumb, pull the screwdriver
from the end guard.
f. Using the screwdriver handle, tap the Xcluder end guard flush with
the edge of the door sweep.
g. Repeat steps a-f for the remaining unguarded door sweep edge.
USE CARE WHEN HANDLING AND CUTTING. ALWAYS
WEAR GLOVES AND SAFETY GLASSES
Xcluder® Pest Control Door Sweep Installation Instructions
Use for Part #s: 162600, 162602, 162604, 162608, 162620, 162622, 162624, 162628, 162638, 162640
Thank you for your purchase of an Xcluder Pest Control Door
Sweep, the best way to close the door on unwanted pests.
Tools Required:
1. Phillips head screwdriver
2. 1/4” nut driver — Commercial Sweeps Only
(Part #’s: 162602, 162622, 162640)
3. Drill and 7/64” bit
4. Hacksaw – only needed if the sweep needs to be trimmed to fit
5. Sturdy shears - only needed if the sweep needs to be trimmed to fit
4a-14a-2
4c 4d
4f
2
1
Pre-installed End Guard
DO NOT TRIM THIS END
Version—BG2, 1-11-18
750 W Lake Cook Rd, Suite 480 | Buffalo Grove, IL 60089 | Ph: 847.495.4700
w w w . G e t X c l u d e r . c o m
Installation Instructions: (Continued)
5. Close door. Hold sweep at bottom of door. Position so that the bottom of the sweep is 1/16” above threshold.
6. At the slots, drill pilot holes through the rubber and into the door using a 7/64” bit
7. Attach sweep with the included stainless steel mounting screws.
IMPORTANT: Make sure the door sweep makes even contact.
Xcluder® Pest Control Door Sweep Installation Instructions
Use for Part #s: 162600, 162602, 162604, 162608, 162620, 160622, 160624, 160628, 162638, 162640
Version—BG2, 1-11-18
Xcluder Rodent Proof Door Sweep Limited Warranty
OUR GUARANTEE: Xcluder® Door Sweeps will stop mice and rats or we’ll send you a replacement, free.
WHAT DOES THIS WARRANTY COVER?
Xcluder® door sweeps are warranted to you by Global Material Technologies, Inc. (GMT) to be free from defects in material and
workmanship at the me of purchase and to be impenetrable to mice and/or rats for the lifeme of the product. For this Lifeme Limited
Warranty to apply, the sweep must have been properly installed as described in the installaon instrucons and be in good, serviceable
condion.
WHAT DOES THIS WARRANTY NOT COVER?
This warranty does not cover damage from abuse, normal wear or tear, or any use not in accordance with the instrucons provided. This
warranty does not cover penetraons by mice and rats resulng from a worn out, improperly installed or damaged (other than by a
mouse or rat) sweep. This warranty does not cover damages such as the cost of repairing or replacing other property that is damaged due
to a defect in the sweep, the cost for transportaon of the sweep to get warranty service, loss of me, loss of use, or other consequenal
or incidental damages.
HOW LONG DOES THIS WARRANTY LAST?
For Commercial Door Sweeps: This Lifeme Limited Warranty begins on the date of purchase and lasts for the lifeme
of the product.
For Residenal and Low-Prole Door Sweeps: The Limited Warranty begins on the date of purchase and lasts for a period of ve (5)
years.
HOW TO RECEIVE WARRANTY SERVICE?
Call customer service at 847-495-4730 or email warranty@gmt-inc.com. At our discreon GMT may require pictures and/or return of
the damaged sweep as a condion of warranty service. If requested, return shipping for the damaged sweep will be at GMT’s expense.
Indice
