Graco 24V555 Manuale utente
3A3091A
EN
Instructions
Battery Kit
Replacement battery for use with XDM6, XDM12, and XDI12 Electronic Lubricant Meters.
For professional use only.
Kit No.: 24V555
Important Safety Instructions
Read all warnings and instructions in this manual
and the XDM6 and XDM12 Dispense Valve
manual or XDI12 Electronic Lubricant Meter
manual. Save all instructions.
SKIN INJECTION HAZARD
High-pressure fluid from meters, a dispensing device,
hose leaks, or ruptured components will pierce skin.
This may look like just a cut, but it is a serious injury
that can result in amputation. Get immediate surgi-
cal treatment.
• Do not put your hand over the fluid outlet.
• Do not stop or deflect leaks with your hand, body,
glove, or rag.
•Relieve pressure when you stop dispensing and
before cleaning, checking, or servicing equipment.
• Tighten all fluid connections before operating the
equipment.
Battery Installation
23A3091A
Battery Installation
The reference numbers used in the following instruc-
tions refer to the Meter Parts, page 3.
Always use new parts included in the kit.
1. Relieve pressure. See pressure relief procedure
included in your dispense valve instruction manual.
2. Attach the disposable grounding wrist strap (8) (not
shown, included in the kit) to your wrist. Connect the
adhesive-backed copper foil at the other end of the
strap to any convenient electrical ground, such as
the grounding screw or metal case of a grounded
electrical outlet.
3. Lift the bottom edge of the black cover (1) away from
the meter (2), and pull the cover off. Remove and
discard the screws (6) and the large o-ring (4). Dis-
pose of the screws and o-ring according to all stan-
dards for disposal.
4. Insert a small, flat screwdriver or similar tool
between the battery and the positive terminal (bat-
tery retainer) in the electronic control to remove the
battery as shown in FIG. 1.
5. Insert the new battery with the negative side of the
battery position to the bottom of the battery holder.
Press the battery firmly down until the positive ter-
minal clips above the battery. See FIG. 2 (Battery
Side View) to identify the negative and positive
sides of the battery.
6. Install the new large o-ring (4) over the lip on the top
of the metering unit (2). Align the notch on the side
of the electronic control (3) with the notch on the
side of the metering unit (2).
7. Install new screws (6). Tighten the screws in a diag-
onal pattern to 3 in-lbs to 5 in-lbs (0.34 N.m to 0.57
N.m) until a complete seal is obtained as shown in
the DETAIL in FIG. 3, page 3.
8. Install the cover so the rolled-in edges are parallel
with the inlet fluid passage of the metering unit.
FIG. 1
FIG. 2
Battery Side View
Battery Installation
3A3091A 3
Meter Parts
*These parts are included in Battery Kit 24V555.
Technical Data
Panasonic®is a registered trademark of
Panasonic Corporation.
FIG. 3
1
3
2
4
6
6
DETAIL
4
Underside view
1
63
4
2
7
Ref. Description Qty.
1 GUARD, impact 1
2 METERING UNIT, gal-
lon/quart/pint/liter
1
3 ELECTRONIC CONTROL 1
4* O-RING 1
6* SCREW 6
7* BATTERY 1
8* STRAP, grounding, disposable (not
shown)
1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Battery
Battery Specifications Panasonic®CR2450 3V
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM XXXXXX
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2014, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
www.graco.com
Revision A, June 2015
Graco Information
For the latest information about Graco products, visit www.graco.com.
For patent information, see www.graco.com/patents.
TO PLACE AN ORDER, contact your Graco distributor or call to identify the nearest distributor.
Phone: 612-623-6928 or Toll Free: 1-800-533-9655, Fax: 612-378-3590
Altri manuali Graco Accessori per fotocamere
