
1.Open the over of the PIR sensor
with a flat s rewdriver. A gentle
twisting will remove the over of
the PIR Sensor.
2.Insert two 1.5V “AA” alkaline
batteries in the PIR sensor,
observe polarity.
3.Set the house odes (1-16), it
must be mat hing with the ode
set in the hime re eiver.
(Diagram A)
4.Use the 3position slide swit h to
sele t a different hime tune.
Note - PIR sensor and bell push-
es an be set to different tunes.
(Diagram A)
5. Use 2-position slide swit h to
adjust the HI/LOW sensitivity.
Fa tory pre-set to low sensitivity.
This adjusts the range of the PIR
Sensor. (Diagram A)
6.Lo ate a good position indoor or
outdoor within the dete tion
range of the PIR Sensor.
7.Pla e the ba k plate in the hosen
position, drill two 4.76mm holes
and insert the wall plugs, then
tighten the plate on wall with the
s rews supplied. Do not mount
on or next to a metal surfa e.
8.Position the over over the ba k
plate so that the lip on the ba k
plate engages into the slot. Make
sure the rubber gasket is properly
seated. Push the PIR over ba k
to the ba k plate until it snaps into
position.
9.The PIR Sensor dete ts any
INSTALLATION
•For use with wireless himes
• Use instead of, or in onjun tion with
other bell pushes to alert the approa h
of visitors/intruders
•433MHz, 16 ode, up to 50M range
• Dete tion range 3M
• Dete tion angle 60 degree
•2x1.5V AA battery
• Indoor & Outdoor Use
• CE-EMC / LVD / R&TTE approved
• RoHS omplian e
DW080A-C
Sec rity PIR Sensor