Greyline 12 Foot DX Manuale utente
ASSEMBLY INSTRUCTIONS
Tools Required: 5/32” Allen Wrench
Assembly Instructions:
1.) Before you begin:
a) Dig a hole 36” deep and 12” diameter (or sized as required). Line the bottom of the hole
with 3-6” of small gravel or sand.
b) Place PVC ground sleeve (A) into hole and fill outside of PVC with concrete to within 1” of
top of ground sleeve. IMPORTANT: Keep concrete out of interior of ground sleeve.
c) Insert a pole section into the ground sleeve and use a level to make sure that the pole is
completely vertical before concrete cures.
d) Remove pole section and let concrete set at least 24-48 hours before proceeding with
installation.
2.) Install Feed through Lower Fiberglass Insulator
a) Locate ASSEMBLY 1 and insert Feed Line, as shown in
diagram. Then, set it aside.
3.) Attach Upper Fiberglass Insulator
a) Locate ASSEMBLY 2. Extend Fiberglass
Insulator, and attach with screws
provided.
ASSEMBLY INSTRUCTIONS
4.) Final Assembly: Attach Assembly 1 to Assembly 2 as shown:
a) Attach Assembly 2 to Assembly 3 in a similar manner.
b) Attach Assembly3 to Assembly 4/5/6 in a similar manner.
c) NOTE: Depending on which model you have purchased, you may need to repeat step b
(above) up to three times.
d) Attach “Top Section”
e) Using two people, lift mast and place into PVC Sleeve in ground.
f) If desired, a “Cleat” (for tying Flag rope) can be installed into Assembly 3.
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali Greyline Antenna
Manuali Antenna popolari di altre marche
Alfa Network
Alfa Network APA-L01 Manuale utente
Naval
Naval PR-422CA Manuale utente
Feig Electronic
Feig Electronic ID ISC.ANTH200/200 Series Manuale utente
TERK Technologies
TERK Technologies TV44 Manuale utente
Directive Systems & Engineering
Directive Systems & Engineering DSE2324LYRMK Manuale utente
HP
HP J8999A Manuale utente
