Grizzly H6175 Manuale utente
Model H6175 Half Face
Power Mask
Grizzly’s Model H6175 Half Face Power Mask
(shown in Figure 1) facilitates easy breathing and
protects against industrial contaminates.
To use the Half Face Power Mask:
1. Remove the mask and all components from
its container.
2. Unscrew the cartridge cover as shown in
Figure 2.
3. Place a pre-filter on the outside of the car-
tridge with the soft side to the air.
4. Twist on the cartridge cover.
5. Open the battery pack cover and install four
AA batteries (Figure 3). Replace the cover.
6. Plug the power cord into the battery pack.
7. Place the mask on your face and the plastic
head strap on your head.
1. Read and understand these instructions
before using this power mask.
2. This mask does not provide oxygen.
Always follow the Permissible Exposure
Limit (PEL) guidelines set by OSHA .
3. Do not use in atmospheres immediately
dangerous to life or health.
Failure to heed these warnings may result in
sickness or death.
Figure 1. Model H6175 Half Face Power Mask.
Figure 2. Cartridge cover removed.
Figure 3. Battery pack cover opened.
8. Adjust the mask to your face by tightening or
loosening the side straps (Figure 4).
9. Clip the side straps together and turn the bat-
tery pack ON.
10. To check for positive pressure, place your
hand over the exhalation valves and exhale
gently:
—If the mask bulges slightly and no leak is
detected, a proper fit has been obtained.
—If the mask leaks air, adjust the tension
of the elastic straps until a proper fit is
obtained and no air leaks are detected.
11. To check for negative pressure, place your
hand over the cartridge and inhale gently:
—If the mask pulls closer to your face with no
leaks between the mask and your face, a
proper fit has been obtained.
—If the mask does not pull closer to your
face, adjust the elastic straps until no air
leaks are detected.
Maintenance:
Store the mask in a sealed (air tight) container to
increase the lifespan of the filter cartridges.
It is important to keep clean, functioning cartridg-
es and filters in your power mask. Replace them if
they become damaged, soiled or when breathing
becomes difficult.
Always replace the cartridge and pre-filter with the
NIOSH approved Grizzly Model H6892 pre-filter
and Grizzly Model H6893 Filter Cartridge.
If you need additional help with this procedure,
call our service department at: (570) 546-9663.
Figure 4. Adjusting the side straps.
COPYRIGHT © JUNE, 2004 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#CA6382 PRINTED IN TAIWAN
Indice
Altri manuali Grizzly Sensore di sicurezza
