Hama TS37F Manuale utente

186351

TS37F

Outdoor Sensor

Außensensor

RUS SK

RUS

FIN

Instrukcja obsługi

Használati útmutató

Manual de utilizare

Návod kpoužití

Návod na použitie

Manual de instruções

Bruksanvisning

Руководство по эксплуатации

Работна инструкция

Οδηγίες χρήσης

Käyttöohje

Operating Instructions

Bedienungsanleitung

Mode d‘emploi

Instrucciones de uso

Gebruiksaanwijzing

Istruzioni per l‘uso

GOperating instruction

Controls and Displays

AMeasuring station

1. Battery compartment

2. Channel switch (CH1, CH2, CH3)

3. Recess for wall mounting

Thank you for choosing aHama product.

Take your time and read the following instructions and information

completely.Please keep these instructions in asafe place for future

reference. If you sell the device, please pass these operating instructions

on to the new owner.

1. Explanation of Warning Symbols and Notes

Warning

This symbol is used to indicate safety instructions or to draw your

attention to specichazards and risks.

Note

This symbol is used to indicate additional information or important

notes.

2. Package Contents

•TS37F Outdoor Sensor

•These operating instructions

3. Safety Notes

•The product is intended for private, non-commercial use only.

•Do not operate the product outside the power limits given in the

specications.

•Do not use the product in moist environments and avoid splashes.

•Do not use the product in the immediate vicinity of heaters or other

heat sources or in direct sunlight.

•Do not use the product in areas wherethe use of electronic devices

is not permitted.

•Do not put the product near interference elds, metal frames,

computers, TVs, etc. Electronic devices and window frames can

negatively affect the product’sfunctionality.

•Do not drop the product and do not expose it to any major shocks.

•Do not open the device or continue to operate it if it becomes

damaged.

•Do not attempt to service or repair the product yourself.Leave any and

all service work to qualied experts.

•Keep the packaging material out of the reach of children due to the

risk of suffocation.

•Dispose of packaging material immediately according to locally

applicable regulations.

•Do not modify the product in any way.Doing so voids the warranty.

•Use the product for its intended purpose only.

•Protect the product from dirt, moistureand overheating, and only use

it in adry environment

•Keep this product, as all electrical products, out of the reach of

children!

•Use the item only in moderate climatic conditions.

Warning –Batteries

•When inserting batteries, note the correct polarity (+ and -

markings) and insert the batteries accordingly.Failure to do so

could result in the batteries leaking or exploding.

•Only use batteries (or rechargeable batteries) that match the

specied type.

•Beforeyou insert the batteries, clean the battery contacts and the

polar contacts.

•Do not allow children to change batteries without supervision.

•Do not mix old and new batteries or batteries of adifferent type

or make.

•Remove the batteries from products that arenot being used for

an extended period (unless these arebeing kept ready for an

emergency).

•Do not short-circuit batteries.

•Do not charge batteries.

•Do not throw batteries in a re.

•Keep batteries out of the reach of children.

•Never open, damage or swallow batteries or allow them to enter

the environment. They can contain toxic, environmentally harmful

heavy metals.

•Immediately remove and dispose of dead batteries from the

product.

•Avoid storing, charging or using the device in extreme temperatures

and extremely low atmospheric pressure(for example, at high

altitudes).

4. Getting started

•Open the battery compartment (1) and insert two AAA batteries with

the correct polarity.

•The battery compartment additionally contains the channel switch (2),

which allows you to switch between the channels CH1, CH2 and CH3.

Set the channel switch to the desired channel.

•Then close the battery compartment cover.

Replacing the batteries

•Open the battery compartment (1), remove and properly dispose of

the dead batteries and insert two new AAA batteries with the correct

polarity.Then close the battery compartment cover.

Note

Beforeuse, make surethat you insert the batteries in the measuring

station rst and then in the base station.

5. Installation

Note –Installation

•We recommend initially placing the base and measuring stations in

the intended locations without installing them and making all the

settings described in 6. Operation.

•Only install the stations once the appropriate settings have been

made and astable wireless connection is established.

Note

•The wireless transmission range between the measuring and base

stations is up to 30 metres in open spaces. Beforeinstallation, ensure

that wireless transmission will not be disrupted by interference or

obstacles like buildings, trees, vehicles, high-voltage lines, etc.

•Beforethe nal installation, ensurethat thereissucient reception

between the intended installation locations.

•When installing the measuring station, ensurethat it is protected

from direct sunlight and rain.

•The international standardheight for measuring air temperatureis

1.25 m(4ft) above ground.

Warning –Batteries

•Buy special or suitable installation material from aspecialised

dealer for wall-mounting.

•Ensurethat no faulty or damaged parts areinstalled.

•Never apply force during installation. This could damage the

product.

•Beforeinstallation, ensurethat the chosen wallissuitable for the

weight to be installation, and make surethat thereare no electrical

wires, water,gas or other lines in the wall at the installation site.

•Do not mount the product above locations wherepersons might

linger.

•We recommend installing the measuring station securely on an

outdoor wall.

•Install an anchor,screw,nail, etc. in the wall of your choice.

•Hang the measuring station using the opening intended for this

purpose (3).

6. Operation

6.1. Connection to the measuring station

•To connect the base station and the measuring station, place the two

devices as close together as possible.

•After you insert the batteries, the base station automatically searches

for aconnection to the measuring station and performs initial setup.

•If the device does not connect automatically,the manual search

program on the base station must be started.

Note

•Initial setup takes approximately 2minutes.

•During the connection attempt, the radio symbol on the base

station will ash.

•Do not press any buttons during setup. Otherwise, values may

not be transmitted correctly and thereisarisk of value errors and

inaccuracies.

•The setup process is completed when the indoor and outdoor

measurement data is displayed on the base station.

•The measured value is automatically updated by the base device

about every 45 seconds.

•If the temperatureisoutside of the measuring range, --.-(lower

than minimum temperature) or --.-(higher than maximum

temperature) will appear on the temperaturedisplay.

6.2. Selecting the channel/Other measuring stations

Note

•Ensurethat the base station and measuring station areset to

the same channel. Suitable base stations can be found at www.

hama.com

•The transmission channel on the supplied measuring station can be

changed/set (CH1, CH2, CH3).

•The measuring station is suitable for the following base stations:

186313

6.3. Low battery charge

Measuring station

If the batteries need to be replaced, the symbol for low battery charge

will appear next to the outdoor temperaturedisplay on the base

device. Replace the batteries immediately.

Note –Replacing the batteries

•Note that the stations have to be resynchronised each time after

you change the batteries in the measuring or base station.

•To do this, remove the batteries from the other station and then

reinsert them, or change them as required.

7. Care and Maintenance

•Only clean this product with aslightly damp, lint-free cloth and do not

use aggressive cleaning agents.

•Make surethat water does not get into the product.

8. Warranty Disclaimer

Hama GmbH &CoKG assumes no liability and provides no warranty for

damage resulting from improper installation/mounting, improper use of

the product or from failuretoobserve the operating instructions and/

or safety notes.

9. Technical Data

Measuring station

Power supply 3.0 V

2xAAA batteries

Measuring range

Temperature -10°C –+60°C/ 14°F –140°F

Measurement increments

Temperature 0,1°C /0,2°F

Temperaturemeasurement cycle ~45s

Range ≤30 m

10. Declaration of Conformity

Hereby,Hama GmbH &CoKG declares that the radio

equipment type [00186351] is in compliance with Directive

2014/53/EU.The full text of the EU declaration of conformity

is available at the following internet address:

www.hama.com->00186351->Downloads.

Maximum radio-frequency power transmitted 0.021 mW

Frequency band(s) 433 MHz

Questo manuale è adatto per i seguenti modelli

Indice

Lingue:

Manuali Accessori popolari di altre marche

Hillco

Hillco 2810 Manuale utente

Siemens

Siemens QSA2700D Manuale dell'operatore

Contours

Contours ZY024 Manuale utente

Saivod

Saivod VS621 Manuale utente

Virtuox

Virtuox VirtuCLEAN 2.0 Manuale utente

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuale utente

Z-Wave

Z-Wave HSD-200Z Manuale utente

turck

turck FMX-IM-2UPLI63FX Manuale utente

Decagon Devices

Decagon Devices 10HS Manuale utente

UPPAbaby

UPPAbaby Cup Holder Manuale utente

Elko

Elko SmartSensor Leakage Wireless Manuale utente

Grizzly

Grizzly H8371 Manuale utente

Panasonic

Panasonic HG-T Series Manuale utente

IFM Electronic

IFM Electronic Efector 250 Series Guida di riferimento

DigiDesign

DigiDesign 888/24 I/O Manuale utente

PROZIS

PROZIS QUAY Manuale utente

patagonia

patagonia PSI Vest Manuale utente

SFC Energy

SFC Energy EFOY GO! Manuale utente