
Page 3For technical questions, please call 1-800-444-3353.SKU 67125
or invalids and whenever the heater
is left operating and unattended.
Be sure Heater is on a stable surface3.
when operating to avoid overturning.
Do not place the heater near a bed4.
because objects such as pillows or
blankets can fall off the bed and be
ignited by the heater.
Always unplug the heater when not in5.
use.
Always plug heaters directly into a6.
properly grounded outlet/receptacle.
Never use with an extension cord or
re-locatable power tap (outlet/power
strip).
Do not operate heater with a7.
damaged cord or plug or after the
heater malfunctions, has been
dropped or damaged in any manner.
Discard heater or have examined by
a qualied repair technician.
Do not run cord under carpeting.8.
Do not cover cord with throw rugs,
runners, or similar coverings. Do
not route cord under furniture or
appliances. Arrange cord away from
trafc area and where it will not be
tripped over.
Check your heater cord and plug9.
connections.
Faulty wall outlet connections ora.
loose plugs can cause the outlet or
plug to overheat. Be sure the plug
ts tight in the outlet.
Heaters draw more current thanb.
small appliances, overheating of
the outlet may occur even if it has
not occurred with the use of other
appliances.
During use, check frequently toc.
determine if your plug outlet or
faceplate is HOT! If so, discontinue
use of the heater and have a
qualied electrician check and/or
replace the faulty outlet(s).
Use only in dry environments. Do not10.
use in bathrooms, laundry area, near
sinks or other sources of water.
Do not use outdoors.11.
To disconnect heater, rst turn 12.
controls to off, then remove plug from
outlet.
Do not insert or allow foreign objects13.
to enter any ventilation or exhaust
opening as this may cause an electric
shock or re, or damage to the
heater.
To prevent a possible re, do not 14.
block air intakes or exhaust in any
manner. Do not use on soft surfaces,
like a bed, where openings may
become blocked.
A heater has hot and arcing or15.
sparking parts inside. Do not use it
in areas where gasoline, paint, or
ammable liquids are used or stored.
Use this heater only as described16.
in this manual. Any other use not
recommended by the manufacturer
may cause re, electric shock, or
injury to persons.
It is normal for the plug to feel warm17.
to the touch. However a loose t
between the receptacle and plug
may cause overheating and distortion
of the plug. Contact a qualied
electrician to replace a loose or worn
outlet.