Hawaiian shaved ice S700 Manuale utente

Electric Snow Cone Machine

Model #S700

Instruction Manual

SAVE THIS MANUAL FOR FUTURE USE

Registration

You may register this ice shaver through our website at

www.HawaiianShavedIce.com/register.html

Table of Contents

General Warnings 3

Usage Precautions 7

Warranty 9

Assembly/Parts Diagram for S700 (Fig. A) 11

Operation for S700 (Fig. B) 12

Assembly and Use 13

Cleaning 14

Shaved Ice Recipes 15

Mary Mack’s, Inc.

DBA Hawaiian Shaved Ice

321 Goldsboro Street

Newton Grove, NC 28366, USA

1-800-742-8334 –toll free

910-247-4152 –direct

770-234-6333 –fax

General Warnings and Safeguards

CAUTION

To prevent property damage and personal injury, it is important that you read

and follow all general warnings, safeguards and instructions.

Read the instructions provided in this booklet carefully because

they give important information with regards to the installation, use

and maintenance. Keep this manual for future reference.

This ice shaver is intended for household use only.

This ice shaver has an extremely sharp blade. You should use

extreme caution during assembly, operation, disassembly and

while cleaning the unit. If the blade becomes broken or loose,

do not use the appliance.

After unpacking the unit and before each use, make sure the

mechanical parts of the unit and all its attachments are intact. Look

for any foreign objects before operating the ice shaver. When in

doubt, do not use the appliance and refer to an authorized repair

center.

To prevent electrical shock to yourself or others, do not immerse

the cord, plugs, motor unit or any other electrical parts in water or

other liquids of any kind.

Use extreme caution to make sure you never place your fingers or

other items into the machine or the machine’s moving parts.

Do not operate the machine without ice.

Use this appliance for no more than 2 continuous minutes. Failure

to obey this may cause the ice shaver to overheat. Allow the

appliance motor to cool down before repeat usage.

All packing elements (plastic bags, polystyrene, etc.) should be

kept out of the reach of children because they are potentially

hazardous.

Before plugging the appliance into a power source, make sure the

voltage details marked on the appliance seal/plaque correspond to

those of your power supply. The seal/plaque is located on the

motor unit.

This appliance has a polarized plug (one blade is wider than the

other). As a safety feature, this plug will fit a polarized outlet only

one way. If the plug does not fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician. Do not attempt

to defeat this safety feature.

In the event the wall socket and the appliance plug are not

compatible, have the socket changed by a qualified professional

who must also ensure that the cross section of the socket wiring

corresponds to the power consumed by the appliance. Generally

speaking, adapters, multiple sockets, extension cords and/or drop

cords should not be used. However, if necessary, only use single or

multiple adapters and extension cables which comply with the

existing safety standards, making sure the current carrying capacity

limits marked on the single adapter and on the extension cables as

well as the maximum power limit marked on the multiple adapter

are not exceeded.

Do not use the machine around a hot surface or hot appliances.

Keep the appliance away from stovetops, broilers, ovens or any

other potentially hot appliance. Pay special attention to the

electrical cord to prevent it from touching a hot surface.

This appliance must be used only for the purposes it was designed

for, (i.e. for crushing/shaving ice in the home). Any other use must

be considered improper and therefore dangerous. The

manufacturer cannot be held responsible for any damages deriving

from improper, incorrect or unreasonable uses.

The use of any additional accessory attachments not

recommended by HawaiianShavedIce.com is not suggested.

Failure to obey this warning may cause fire, electric shock or injury

to yourself or others.

The use of any electric appliance requires the user to observe basic

rules.

In Particular:

Never touch the appliance with wet or damp hands.

Never use the appliance barefoot.

Never pull the electrical cable or the appliance itself to remove the

plug from the electrical socket.

Avoid all contact with any moving parts of the appliance.

Never leave the appliance exposed to the elements (rain, sunshine,

etc.).

Never let children or those unable to operate the appliance use it

unattended. Do not leave the unit unattended while plugged into a

power source.

Before any cleaning, maintenance, assembly or disassembly,

make sure that the ice shaver is disconnected from the main

power supply by unplugging it.

Should the appliance be out of order and/or operating inefficiently

switch it off and do not attempt to tamper with it. For any repairs,

approach an authorized service center only and request the use of

original spare parts. Failure to comply with the above might result in

compromised safety of the appliance.

Should you decide to stop using the appliance, it is advisable to

render it unusable by cutting the electrical cable after unplugging it

from the main power supply.

Furthermore, it is advisable to render all hazardous parts of the

appliance harmless, particularly for children, who might play with

the discarded appliance.

Installation must be carried out in compliance with the

manufacturer’s instructions. Incorrect installation can cause

damage to people, animals or objects for whom the manufacturer

may not be held responsible.

In order to avoid dangerous overheating it is advisable to unwind

the electrical cable completely and use the appliance as

recommended in the “Usage Precautions” paragraph.

Never leave the appliance plugged in when not needed. Unplug

from the power supply plug whenever the appliance is not in use.

Never obstruct the openings or slits for ventilation and heat

dissipation.

Should the electrical cable of this appliance become damaged,

have it replaced by a manufacturer authorized after-sales service

center only because special tools are required.

The manufacturer reserves the right to make any changes

considered necessary for industrial, commercial or design

improvements or to comply with particular standards. It is advisable

to pay particular attention to those warnings highlighted with the

symbol.

Usage Precautions

Before using this appliance for the first time or after a long period of

disuse, wash the shaver bowl assembly cup in warm water with

dish soap, rinse and dry thoroughly.

Before each use of the appliance, check that it is mechanically

intact. The motor unit, the shaver bowl assembly and the support

base must not be cracked or broken in any way. The sheath and

the plug should not be cracked or broken. However if they are,

remove the plug immediately from the socket and take the

appliance to an authorized technical center for necessary repairs.

Before plugging in the appliance, check that the switch is not in the

“On” position.

Ensure that the ice shaver and the cable are not too close to the

edge of the table or work surface, that it is not touching heat

sources, and that it is not near a sink.

Never immerse the motor unit in water or other liquids.

Use ice cubes that are made from most residential ice makers.

Commercially produced bagged ice may be used as long as the

cubes are not too big.

Substances other than ice should never be placed in the container

shaver bowl assembly.

Never run the appliance while empty.

Never run the appliance before it has been correctly mounted on its

base.

Never put your fingers into the bowl assembly because the blade is

very sharp and may cause injury.

Do not damage the blade by using metal implements.

Do not attempt to sharpen the blades; if necessary, replacement

blades may be purchased. See page 17 of this instruction manual

for ordering information.

To avoid overheating, do not run the appliance for longer than 2

consecutive minutes. If you need to crush a large quantity of ice, do

so in small batches with pauses in between.

Ice Shaver Specifications

Model S700, Electric Ice Shaver –Snow Cone Machine

Power: 120v, 60 Hz, 55W max

ETL approval

Made in China

Product Warranty

Ice Shaver 1 Year Limited Warranty

Mary Mack’s, Inc. DBA HawaiianShavedIce.com warrants to the original

purchaser that the Hawaiian Snow Cone Machine (Ice Shaver) # S700 shall

be free from material defects in material and workmanship under normal

household use for a period of one (1) year from the original date of purchase

provided that the ice shaver and all parts thereof are used in accordance

with all of the general warnings, safeguards and instructions found in this

instruction manual.

If the product is determined to be materially defective during the warranty

period, your sole remedy and Mary Mack’s, Inc, sole and exclusive liability

shall be limited to the repair or replacement of this product with a new or

refurbished product at Mary Mack’s, Inc. option. This warranty does not

cover exterior or interior finish or damage caused by misuse, scratching,

accident or negligence.

This warranty is extended only to the original purchaser and does not apply

to commercial use or damage to the product (not resulting from defect or

malfunction) while in the possession of the original consumer. Mary Mack’s,

Inc. claims no responsibility for consequential, foreseeable, incidental, or

commercial losses caused as a result of using this product.

If a problem with this ice shaver develops during the warranty period, please

contact Mary Mack’s, Inc. for service. Send a brief letter explaining the

problem along with a copy of your receipt or other proof of the original

purchase date, which will be required before warranty service is rendered.

Be sure to include your name, address and phone number.

Any ice shaver submitted for repair must be sent (transportation charges

prepaid) to the following authorized repair center:

Mary Mack’s, Inc.

Attn: Ice Shaver Repair

321 Goldsboro Street

Newton Grove, NC 28366

If you have any questions concerning the use and/or care of this product or

comments regarding your experience with the product, we would like to hear

from you. Feel free to give us a call at 1-800-742-8334 or email us at

CustomerCare@HawaiianShavedIce.com.

This warranty is valid in the United States of America and Canada only.

Indice

Altri manuali Hawaiian shaved ice Macchina per il ghiaccio

Hawaiian shaved ice

Hawaiian shaved ice S-900A Manuale utente

Manuali Macchina per il ghiaccio popolari di altre marche

Hoshizaki

Hoshizaki KMD-460MWJ Manuale utente

Sub-Zero

Sub-Zero 315I Istruzioni per l’uso

Unold

Unold 48945 Manuale utente

Kenmore

Kenmore 2217402A Manuale utente

Cornelius

Cornelius WM600 Istruzioni operative

GE XPIO43SCSS Manuale utente

Hoshizaki

Hoshizaki KMD-901MAH Manuale utente

Whynter

Whynter FIM-450HA Manuale utente

U-Line

U-Line UMCR014-SC01A Manuale di installazione

Andrew James

Andrew James AJ000522 Manuale utente

Scotsman

Scotsman CME1356 Manuale utente

Scotsman

Scotsman ACM 25 Manuale utente

Kärcher

Kärcher IP 120 Manuale utente

U-Line

U-Line SS1095 Manuale utente

Maytag

Maytag MIM1554WRS - Ice Maker Manuale utente

Hoshizaki

Hoshizaki KM-630MAH Manuale utente

Princess

Princess Yonanas Manuale utente

Unold

Unold 48946 Manuale utente