P A G E | 4
www.hayesfusion.com | HAYES FUSION
IMPORTANT NOTES
Welding procedure
✓Skill and knowledge are required to obtain a good quality joint.
✓Ensure you select the proper temperature according to the pipe manufacturer’s
recommendation.
✓It is important to know the technical information before you use your heating tool.
Heating adapters: You can purchase all socket accessories at www.hayesfusion.com
Welding parameters: Pipe and fitting manufacturers have established qualified fusion
procedures which should be followed precisely. You should obtain a copy of the pipe
manufacturer's procedures or appropriate joining standard for the pipe being fused.
Heating iron temperature: To meet pipe manufacture’s temperature specifications,
the surface temperature of the heating adapters should be measured with a surface
pyrometer prior to initial use and at reasonable time intervals thereafter.
Ensure you test the temperature on the surface of the heating adapters and not on the heating
plate itself. The heater’s built-in thermometer indicates internal temperature and should only
be use for reference.
Show temperature in Celsius: Connect the machine to the proper power source,
then press for a few seconds until the code 000 is shown and then press 6 times
until the code 006 is shown and then press to select Fahrenheit °F or Celsius °C, allow a
few seconds for the heating tool to read the selected temperature mode and start to heat to
the last temperature that was set. If you need to set a new temperature hold the button
to activate the Set mode and then you can choose the proper temperature. Allow a
few seconds for the heating tool to show the temperature that it is currently at and permit
enough time to reach and stabilize the desired temperature.
CAUTION
Heating iron
✓The heater is to be used with AC power only. Check heater to confirm correct power
requirements and only use a power source with the correct voltage and current capacity.
✓Connect heating tool to power and permit sufficient preheating to stabilize the
temperature before the welding process.
✓When welding, if temperature adjustment is needed, please turn off the heating tool first
and turn it on again to adjust the new temperature. Adjustment of the temperature when
it is already set will damage the temperature control components.
✓It is recommended to use an insulated heater bag to store the heating tool when it is hot.
