Heartland 9200 Manuale utente
Fax (616) 754-9690Toll Free Phone 1-800-223-3900
www.heartlandapp.com
Manual #7716.091712
MODEL 9200/7200 GAS RANGE
Installation and Operating Instructions
MODEL 9200 MODEL 7200
Note: Please read these instructions thoroughly before attempting to install this unit.
Save these instructions for future use.
ATTENTION INSTALLER: Leave this manual with appliance.
These symbols on the name plate mean the
product has been design certified by CSA
International. It has been tested to conform to
standard ANSI Z21.1 - 2007.
©
2010 AGA MARVEL
NOTE: The oven door thermometer does no sense temperature. It is for aesthetics only and is non fuctional.
CERTIFIED
C US
1260 E. VanDeinse St. Greenville , MI 48838
WARNING: Improper installa-
tion, adjustment, alteration,
service or maintenance can
cause injury or property
damage. Refer to this manual.
For assistance or additional
information, consult a
agency, manufacturer
(dealer). Please read these
instructions thoroughly
before attempting to install
this unit. Failure to follow
installation instructions will
result in costly service calls.
1
• ALL RANGES CAN TIP
• INJURY TO PERSONS COULD RESULT
• SEE INSTALLATION INSTRUCTIONS
When moving range for service or cleaning.
1 Disconnect electrical power.
.
4. To reinstall, reverse these instructions.
If the information in this manual is not followed exactly, a or explosion may
result causing property damage, personal injury or death.
WARNING
WARNING
WARNING
For Your Safety
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE
VAPOURS OR LIQUIDS IN THE VICINITY OF THIS APPLIANCE
•Do not use the range as a heater.
•Do not heat unopened glass or metal containers in the oven.
•.
•
•Avoid the use of aerosol containers near the range.
•Never place pans, cookie sheets or roasters directly on the oven bottom -use the rack in its lowest position.
•Do not cover the entire bottom of the oven with aluminium foil. Allow at least 1” of space all around pots, pans or
2
Never use the appliance as a space heater to heat or warm the
room. Doing So may result in carbon monoxide poisoning and
overheating the oven.
Never cover any slots, holes or passages in the oven bottom or
cover an entire rack with materials such as aluminum foil. Doing so
blocks airow through the oven and may cause carbon monoxide
poisoning. Aluminum foil linings may also trap heat, causing a re
hazard.
The use of a gas cooking appliance results in the production of heat and moisture in
the room in which it is installed. Ensure that the kitchen is well ventilated: keep natural
ventilation holes open or install a mechanical device. (mechanical extractor hood)
Prolonged intensive use of the appliance may call for additional ventilation, for example
opening of a window, or more effective ventilation, for example increasing the level of
mechanical ventilation where present.
WHAT TO DO IF YOU SMELL GAS!!
•Donottrytolightanyappliance.
•Donottouchanyelectricalswitch;donotuseanyphoneinyourbuilding.
•Immediatelycallyourgassupplierfromaneighbour’sphone.Followthegassupplier’s
instructions.
•Ifyoucannotreachyourgassupplier,calltheredepartment.
Installationandservicemustbeperformedbyaqualiedinstaller,serviceagencyorthegas
supplier.
WARNING
WARNING
WARNING
Gas Models 9200/7200
CONSUMER WARRANTY
ENTIRE PRODUCT – LIMITED ONE YEAR WARRANTY
AGA MARVELwarrants the replacement or repair of all Parts, including gas components of this stove which prove to
for one year from the date of original purchase. Such parts will be repaired or replaced at the option of Aga-Heartland
without charge, subject to the terms and conditions set out below.
TERMS AND CONDITIONS
1. This warranty applies only for single family domestic use when the stove has been properly installed according
to the instructions supplied by Aga-Heartland and is connected to an adequate and proper utility service. Damage due to
and alteration, or the removal or defacing of the serial plate, cancels all obligations of this warranty. Service during this
warranty must be performed by a factory Authorized Service Person.
2. Warranty applies to product only in the country in which it was purchased.
3. Aga-Heartland is not liable for any claims or damages resulting from any failure of the stove or from service
delays beyond their reasonable control.
4. To obtain warranty service, the original purchaser must present the original Bill of Sale, Model and Serial number.
Components repaired or replaced are warranted through the remainder of the original warranty period only.
5. The warranty does not cover expense involved in making this appliance readily accessible for servicing.
7. Adjustments such as calibrations, levelling, tightening of fasteners, or utility connections normally associated with
original installation are the responsibility of the dealer or installer and not that of the Company
8. If the product is installed outside the normal service area, and cost of transportation expenses (tolls, ferry trip charges,
or mileage expenses, etc.) involved in the repair of the product, or the replacement of a defective part, shall be borne
by the customer (owner).
.
TO ENSURE PROMPT WARRANTY SERVICE, SEND IN YOUR WARRANTY CARD WITHIN 10
DAYS OF PURCHASE.
If further help is needed concerning this warranty, contact:
Customer Service
Place of Purchase: ____________________________
Date of Purchase: _____________________________
Serial Number: _______________________________
Model Number: _______________________________
AGA MARVEL
1260 E. VanDeinse St.
Greenville, MI 48838
Fax (616)754-9690
Toll Free Telephone 1-800-223-3900
4
TABLE OF CONTENTS
Cooking Guide 25
Warning 1
Care and Cleaning 26
Electrical Installation 9 Porcelain 26
Exhaust Hood 9 Oven Cleaning 27
Ventless Installation 10 Surface Burners 27
Vented Installation 10 Nickel Trim 28
Installation of Ducting 11 Exhaust Hood Filter 28
Venting Safety Guidelines 12 Oven & Cabinet Light Replacement 28
Gas Line Installation 12 Interior Oven Rack Removal 29
Clearance Diagrams 14, 16 Rack Supports Removal 29
Important Safety Instructions 17 Removal of Oven Door 30
Exhaust Hood Safety 17 Broiling 31
Features 18 Broiling Pan 31
Cooking Controls 18 Setup and Trouble Shooting 32
Oven Features 19 Burner Setup and Adjustment 32
Other Features 19 Air Shutter Adjustment 33
Control Panel Layout 20 Oven Burner Assembly 33
Operation 21 Trouble Shooting Guide 34
Top Burner Operation 21 Conversion Kits and Information 35
Oven Cooking & Lighting 22
Range Thermostat 22
Parts Diagram 37
Power Failure Operation 23
Parts List 38
Manually Lighting the Top Burner 23
Rating
Plate
39
Manually Lighting the Oven Burner 23
Wiring
Diagrams 40
Warranty 3
Clock/Timer 24
Page Page
Positioning the Range 8
5
Assembly and Installation
To fully enjoy your new range, it is important that you read this booklet thoroughly.
shipping damage, inform your dealer immediately!
Caution when unpacking:
Lift the range by the bottom skirt, do not lift by nickel trim.
Unpacking:
Note: to avoid injury, please wear safety equipment, glasses and gloves, while you are unpacking your new range.
1) Unscrew the 20 screws that hold the crate onto the skid. There are 12 along the bottom and 8 along the top.
3) After the screws have been removed, carefully lift the crate over the stove and set it aside.
2) Next with a pair of snips cut the banding that holds the closet in place. Caution metal banding is under tension!
4) Carefully lift the closet off the stove and set it aside.
5) You are now ready to remove the range from the skid.
For 30” units have one person at each end stand beside the skid and carefully lift the range by the bottom skirt, and a third
, bending your knees not your
back!
For 48” units have one person at each end and one person stand beside the skid and carefully lift the range by the bottom
, bending
your knees not your back!
6) Finish unpacking the range, removing packing tape around the doors and in the oven.
Both 30” and 48” Ranges consist of two main parts: The Range Body, and the Closet / Exhaust Hood
Tools required for assembly: Phillips/Robertson #2 Screwdriver & 5/16” ( 8 mm) wrench or crescent wrench
when range is equipped with a cord and plug.
Gliders:
Teflon Glider
1/8” - 1/4”
Figure 1
.
BLANK
6
STOVE
TOP
Gasket - Peel off
backing and stick on.
Bracket
Sheet metal
screw (black)
Steel Washer Nut Machine screw
(Nickel Plated)
-Remember when working with the closet, the closet is top heavy . Use your hand to support it during
installation.
-With a helper,lift closet assembly from box by area that is circled. (See Fig.1 Page 2).
-Rest the closet assembly on the carton,while your helper steadies the closet,peel the closet backing off the
gasket and stick one on each bracket.
-Place closet assembly onto stove body. (See diagram above).
-Line up holes in the bottom (foot) of the bracket with the holes in the stove top,while one person supports the
closet, fasten the closet brackets to the stove top with machine screws.
-To fasten the splashback to the rear of stove, with the Model 7200 use 5 sheet metal screws and washers.
Gasket
Machine screw
Steel washer
Sheet metal
screw
7
Sheet metal
screw 3 1/2" x 10" Exhaust adaptor
Small box contains:
- 3 1/2"x10 exhaust adapter ( not included with woodstove closets.)
Note: maximum run of ducting is 25 linear feet (subtract 5' per 90 deg elbow added to the
exhaust line and 2.5' per 45 deg elbow.)
Back of closet
you are venting outside, attach the 3 1/2" x 10" exhaust adaptor with 4 sheet metal screws. Fasten your
exhaust ducting to the adaptor.
8
Power In
(male receptacle)
Exhaust Hood In
(female receptacle,
from )
Power In
(male receptacle)
Exhaust Hood In
(female receptacle,
from )
Model 9200 Model 7200
Back of stove
Back of stove
1. When the range is fully assembled, recheck all electrical connections especially between
the exhaust hood and the back of the range. As well, check that all nuts and bolts have been
tightened.
2. Ensure teflon gliders and flooring are clean.
3. Caution: On flooring with very rough surfaces or deep, large grooves the appliance may
have to be lifted and slowly slid into position.
4. Put both hands on the trim and carefully push the range into place. Make sure floor is clear
of all debris. Don’t forget to plug in the main power cord and the exhaust hood power
cable before the range is in its final position. See closet installation instructions.
5. To level the range, simply adjust the levelling screws with teflon pads located at the bottom
of each leg. Using a 5/16” (8 mm) open-end wrench, turn the adjusting screw clockwise to
raise up the corner, and counter-clockwise to lower the corner. (Don’t forget the teflon glider
should extend beyond the bottom of the leg by approximately 1/8”-1/4”.)
6. Note: On soft kitchen flooring, the weight of the stove may cause slight depressions in the
flooring. When the range is in position and levelled, you may want to place coasters under the
teflon gliders of each leg to protect the floor. Remove the coasters when moving the range for
cleaning or servicing.
closet
closet
Positioning the Range
Altri manuali per 9200
1
Questo manuale è adatto per i seguenti modelli
1
Indice
Lingue:
Altri manuali Heartland Allineare
Heartland
Heartland 6210 48" Manuale utente
Heartland
Heartland 5210? 4210 Manuale utente
Heartland
Heartland 9200/7200 Manuale utente
Heartland
Heartland 7200 Manuale utente
Heartland
Heartland Toledo XT Manuale di istruzioni
Heartland
Heartland Artisan 5210 Manuale utente
Heartland
Heartland Classic 6200 Manuale utente
Heartland
Heartland 7200 Manuale utente
