
10
General Use
Operating the H95
The source and volume can be changed
using the input and volume selector on the
front panel or using the remote control.
Power Button
The H95 amplifier can be switched on and
off with the power button located on the un-
derside of the amplifier, towards the front of
the unit.
NOTE: When powering up, the H95 takes
a few seconds to calibrate, the outputs are
muted and the volume flashes to indicate
that mute is on. This is normal and is part
of the start-up procedure.
NOTE: When the H95 has been switched
off, wait 30 seconds before powering it on
again.
Headphone Output
Connect the 6.3mm headphone jack to
the front of the H95. This activates the
headphone volume control and mutes the
speaker outputs.
NOTE: Variable Line Output is still active.
Sleep/Auto standby
In compliance with the EU Energy Efficiency
Directive the Hegel device will automatically
switch off after 15 minutes without sens-
ing a signal, or with very low signal on the
speaker outputs. You can disable or change
the Sleep/ Auto Standby settings in the
device’s menu.