Henrad NEW Lecco Manuale di istruzioni
Lecco
Technical Data
Workin pressure:
Tested to withstand 4.0 bar
For technical and installation
information visit our website
.henrad.co.uk/do nloads
NEW
Lecco
Btu/hr @
r
t50˚C
Height Length Henrad Heat emissions Henrad
mm mm Code Watts Btu/hr Price
500 730001 200 682 £600.00
1200
NEW
Lecco
Technical Data
NEW
Technical information
Testing and Operating Pressures
Henrad Lecco has been independently tested to ensure
these radiators perform to a maximum workin
pressure of 4.0 bar.
Finish
Stainless Steel.
Water Treatment
Installation of the system should be properly flushed
and fitted in accordance with the British Code of
Practice for the Treatment of Water in Domestic Hot
Water Central Heatin Systems.
Warranty
Henrad Lecco comes with a 5 year manufacturer’s
warranty.
Henrad (UK) Limited, Marriott Road,
Mexborou h, South Yorkshire S64 8BN.
Telephone: 0844 543 6200 Facsimile: 0844 543 6300
www.henrad.co.uk
Henrad Lecco
Wall Mounting Information
All dimensions in mm.
Place your radiator at least 12.5cm above the floor.
Provide insulation by wrappin PTFE tape on the treads before
installin the valves.
Apply silicone seal fluid to all treated parts containin o-rin s.
Connect your radiator to the utilities after followin all the installation
steps in the manual.
After connectin to the utilities, do not for et to dischar e the trapped
air inside the radiator.
AB
Decorative Cap (x2)
(Only for mirror finished products)
Blind Plug (x1)
90˚
Place you
1
2
1
Place you
2
3
1
2
12 3
A
B
C
D
E
F
G
CD
Wall Mounting
Screw (x4)
Wall Mounting
Bracket (x4)
EF
Wall Plug (x4)
Setscrew (x4)
G
Air Vent (x1)
1- Adjust the hei ht of your radiator by
usin a metric ruler.
2- Set the location of your radiator as
desired, ali n with the round by
usin a spirit level and mark the
position of the wall mountin brackets.
1- Drill holes (Ø 10mm) into the spots
you have marked.
2- Nail the wall plu s (E) in the holes
by usin a hammer.
3- Screw the wall mountin brackets all
the way to the holes with the help of
a screwdriver.
1- Place your radiator into the wall
mountin brackets.
2- Insert the setscrews (F) into the slots
on the mountin brackets (D), adjust
the distance between the wall and
your radiator then ti hten the
setscrews by usin an Allen key (M3).
Altri manuali Henrad Stufa
Manuali Stufa popolari di altre marche
Empire Heating Systems
Empire Heating Systems WCC65 Manuale utente
Wetekom
Wetekom 92 86 43 Manuale utente
Desa
Desa SPC170-F Manuale utente
Watlow
Watlow Watrod Electric Tubular Heaters Manuale utente
Haverland
Haverland ECO-DRY GPS Series Manuale elenco delle parti
Stelpro
Stelpro ASILVC2060 Series Manuale utente