LINE OUT
The LINE OUT is both channels, post-EQ and post-reverb, and provides a balanced,
low impedance signal for use with mixing boards, PA systems, or recording.
HEADPHONE JACK
The HEADPHONE jack will defeat the main speaker (but not the extension speaker
output) and is post-EQ and post-reverb. CAUTION: Listening to headphones at high
volumes can cause permanent hearing loss.
EXTENSION SPEAKERS
You can connect a second speaker cabinet to your JazzAmp. This does not
disconnect the internal speaker, and any extension cabinet must be a minimum of
8 ohms and able to handle over 100 watts. DO NOT CONNECT OR DISCONNECT
AN EXTENSION SPEAKER WHILE THE AMPLIFIER IS ON.
POWER AND FUSES
Your amplier is factory set to either 115 volt or 230 volt power depending on which
country was originally shipped to. The voltage can be changed internally, please
contact Henriksen, Inc. or your dealer for specic instructions. For 230 volt amps,
fuse should be a 1A250V Slow Blow. For 115 volt amps, the fuse should be a
1.6A250V Slow Blow.
FX LOOPS
The FX loops send the signal from the amp post-EQ and return it pre-reverb.
(FX Loop detail on page 5)
