Assembly Instructions2HermanMiller OdeTM Lamp
Note: If at anytime the lamp is moved or it seems to be functioning
erratically, you will need to perform a reset on the lamp.
To Reset Lamp:
. Disconnect power to the lamp for 10 seconds.
. Reconnect power, stand clear of lamp (not touching) for 10
seconds.
. Aer 10 seconds has lapsed touch post to turn lamp on.
TROUBLESHOOTING
Light Use. Before the Ode Light will operate
properly it must be located in the intended
location and then plugged in to the electrical
supply for atleast seconds to allow the
touch sensor to adapt to the light’s
environment.
If the customer wants to move the Ode Light,
they must unplug the Ode Light from the
electrical supply, move to new location. Plug
the Ode Light back in to the electrical supply
and wait at least seconds. The Ode Light
Touch Sensor should operate properly aer
this time has elapsed.
If the Ode Light does not Operate properly,
follow the unplug the Ode Light and wait at
least seconds instruction. Plug the Ode
Light back in to the electrical supply and wait
at least seconds. The Ode Light Touch
Sensor Should operate properly aer this
time has elapsed.
NOT following the recommended elapsed
wait times may cause the Ode Light to Not
Operate or Operate erratically.
For more information about our products and services please visit us at
hermanmiller.com or call () .
© Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. BGWL
® Yand Herman Miller are among the registered trademarks of Herman Miller, Inc.
™ Ode is among the trademarks of Herman Miller, Inc.
Part # 1BG8WL Rev. F
