PULLING CAPACITY
This winch has a capacity of 1700 lbs.
Applying this measurement to practical applications you can use this winch to move the following:
a) Move a load from a dead stop of up to 1700 lbs on level ground
b) Move a water borne craft of up to 4000 lbs
c) Maintain movement of a wheel vehicle up to 5000 lbs
Pulling capacity is reduced as incline increases, for example, rolling capacity is reduced from 5000
lbs on flat ground to 1000 on a 45 degree incline. Please remember that this is indications only and
depends on the vehicle or application that is being applied and the surface .
READ ALL INSTRUCTIONS BEFORE USING THIS TOOL!
1. KEEP WORK AREA CLEAN. cluttered areas invite injuries.
2. OBSERVE WORK AREA CONDITIONS.Do not use tools in damp, wet, or poorly lit locations.
Don’t expose to rain. Keep work area well lit. Do not use electrically powered equipment in the
presence of flammable gases or liquids.
3. KEEP CHILDREN AWAY. Children must never be allowed in the work area. Do not let them
handle machines, tools, or equipment.
4. STORE IDLE EQUIPMENT. When not in use, tools must be locked up in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
5. DO NOT FORCE THE TOOL. It will do the job better and more safely at the rate for which it was
intended. Do not use inappropriate attachments in an attempt to exceed the tool’s capacities.
6. USE THE RIGHT TOOL FOR THE JOB. Do not use a tool for a purpose for which it was not
intended.
7.
DRESS PROPERLY. Do not wear loose clothing or jewelry, as they can be caught in movingparts.
Non-skid footwear is recommended. Wear restrictive hair covering to contain long hair. Always wear
appropriate work clothing.
8. USE EYE, EAR AND BREATHING PROTECTION. Always wear impact safety goggles if you are
producing metal filings or wood chips. Wear dust mask or respirator when working around metal,
wood, and chemical dusts and mists. Use protection when working in a loud or noisy environment.
9.
DO NOT ABUSE THE POWER CORD. Protect the power cord from damage, either from impacts,
pulling or corrosive materials. Do not yank machine’s cord to disconnect it from the receptacle.
10. DO NOT OVERREACH. keep proper footing and balance at all times. Do not reach over or
across running machines.
11. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer performance.
12.
STATUTORY STATEMENT WITHIN THE SAFETY INFORMATION.This appliance is not intended
for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
2
