4. Making checks and adjustments before use
4-1 Checking model number
• Ensurethat the screw driver bit used matches the size of the screw
thread.
The compatible screw thread is shown on the rail section (Image 1).
Check the rail section for this information.
• Adjustmentsand checks are made to each section of the unit when
ordered, to match the screws used (M1.0 to 1.7 <flat head>/M2.0 to 3.0
(pan head).
• Thefactorydefaultsettingscanbeusedforthemajorityofscrews.
However, if the screw head height or shape differs and causes the unit to
operate abnormally, further adjustments of each section may be required.
In this case, check and adjust the following areas.
Check the screw capacity
Check and adjustment of rail oscillation
Check and adjustment of passing plate・holding plate
Check and adjustment of rail oscillation
Check and adjustment of bit guide
Check and adjustment of timer
Check and adjustment of sensor voltage levels
• Therailcanbereplaced easily and quickly in this device to allow different
sized screw threads to be used.
Fine adjustments may be required after replacement of the rail.
These adjustment methods are outlined in a separate section. Please
read the relevant section first.
Caution Adjustments should only be made with the power switch in the
OFF position.
Railclassicationlabel
Image 1
Type
of
Unit
Displayed
NumberrCompatible
Screw Size
Recommended Bit Size
Bit Tip
Size Tip Cross
No.
HSF-01
10 M1.0
Φ1.5 No. 0
12 M1.2
14 M1.4
17 M1.7
20 M2.0 Φ2.0 No. 0 or 1
HSF-02 23 M2.3
26 M2.6 Φ3.0 No. 1
30 M3.0 Φ3.2 No. 1 or 2
- 5 -