7
EN
Important Safety Instructions
Before using this machine, read this section and follow the instructions to properly use
this machine.
Installation
The unit should be used in a temperature and humidity-controlled room.
Keep the unit away from a place with poor ventilation, in dust or metal pieces.
Do not place any objects on the unit.
The place to install the unit should be vibration-free and the unit should be securely fixed. If the
unit is installed on the wall or on a high place, make sure to use the attached Mounting Bracket to
fix it securely.
Do not install the unit close to high voltage equipments.
Handling
Install a leakage breaker and safety breaker on the input power source and connect the ground to
use the unit.
Connect to a power source of the specified voltage.
Do not use with other drivers or devices except the models listed in this operation manual.
If the protection circuit works due to overheat, stop operation immediately, pull the power plug
from the outlet and send it back to your HIOS distributor for repair.
The unit may automatically stop in use when the protection circuit works due to overcurrent, etc.
Turn o the power switch once and turn it on in 5 seconds for restart.
If the unit stops while in screw fastening, make sure to check the torque of the fastened screw.
Do not disassemble or modify the unit.
Do not drop the power Supply or subject it to violent impact.
Do not drag the unit by its driver cord or AC cord. Keep the cords away from foreign objects, oil or
something sharp.
Make sure to grasp the plug section to disconnect the AC cord from the outlet.
Turn the unit o and disconnect the AC cord from the outlet when the unit is not in use.
IMPORTANT SAFETY INSTRUCTIONS-SAVE THESE INSTRUCTIONS.
DANGER-TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. CAREFULLY FOLLOW THESE
INSTRUCTIONS.
Selection of Power Supply Cord:
Use in U.S.A. - Use UL Listed detachable power supply cord, No.18AWG,3 conductors, exible cord,
rated 10A, VW-1, 80°C, minimum 1.8m, maximum 3 m long. Provided with a molded-on, non-polarized
attachment plug with a 15A, 125V (NEMA5-15P) or 15A, 250 V (NEMA 6-15P) conguration and a
molded-on connector which mates with the Power Inlet.
The following exible cord type may be used: S, SE, SO, SP-3, SPT-3, ST,STO, SJ, SJE, SJO, SJT, SJTO, SP-2,
SPE-2, SPT-2, SV, SVE, SVT.
Use in countries other than U.S.A. - Use IEC60227 certied PVC exible power supply cord, marked
H03VVF or H05VVF, 3C x 0.75mm2, rated min. 10A, 250V
