HIOTH User Manual
HIOTH TECHNOLOGY CO.,LTD.
sive, and stick it to the door or window. If you want to replace the installation position in the fu-
ture, you can also take off the detector, and stick the device once more time.
DOOR/WINDOW DETECTOR INSTALLATION
Decide which doors/windows to be protected by Door/Window Detectors, (usually the front and
back doors as a minimum will have Door/Window Detectors fitted). Additional detectors may also
be fitted where required to other vulnerable doors or windows (e.g. garage, patio/conservatory
doors etc.).
1. Ensure that the system properly powered
The Door/Window Detector is a passive wireless sensor, supplied by solar energy (or use
CR1216 battery).
2. Using the adhesive tape to fit detector on the door or window.
3. Fit the magnet to the moving part of the door/window opposite the detector using the adhe-
sive tape.
4. Ensure that the parallel gap between the magnet and detector is less than 15mm and that the
matching line on the magnet is pointing towards and aligned with the line on the detector.
5. After proper installation and test, put the battery cover back to the detector and the detector
enters the normal.
Safety Notice
During installation, protect the device from any physical damage by dropping or bumping. If
happened, please contact the supplier for maintenance.
Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid
damage.
Avoid overexertion during operation, to protect device from mechanical damage.
Pay attention to the using range.
Read all instructions and documentation and save for future reference.
