7
hivolt.de GmbH & Co. KG
Oehleckerring
40 ∙D-22419 Hamburg ∙Germany ∙+49 40 537122-0 ∙+49 40 537122-99 ∙[email protected] ∙www.hivolt.de 2.4 Interlock
The device incorporates an interlock circuit through which the supply voltage of the high voltage
sources is switched. It is a closed circuit with three switching points (break contacts). Its source
voltage is 24 V (carried out via +24V Ilck), quiescent current is 10mA. The switching points are:
1. Connector X4 Power / Interlock:
with terminals +24V Ilck and Interlock, the device can be looped into an interlock circuit
(potential-free break contact); these terminals must be connected together in order to allow
the high voltage sources in the device to be switched on;
2. Connector X1:
with IL_IN (X1.3) and IL_R (X1.16) the device can be looped into an interlock circuit (potential-
free break contact); if these pins are not used, they can be bridged using the DIP switch in the
device;
3. Lever key HV on / HV off on the front panel.
Only if all three contacts are closed, the supply voltage of the high voltage sources will be switched
on. The device will then still be in the Interlock shutdown state. The high voltage generation is not
functionally activated till the Interlock shutdown state is finished by Shutdown Reset.
The HV on display indicates that the supply voltage of the high voltage sources is switched on.
The device must be disconnected from its power supply before carrying out any works on the test
set-up or before touching the output terminals.
3Technical Data
Parameter Conditions
Supply voltage, VS24VDC ±10%
Supply current, ISVS= 24V <1.6ADC
Input voltage range Control input -10.0V – +10.0V
Max. input voltage ±18V
Input resistance 50kΩ
Gain 300 ±1%
Offset ≤200mV
Output voltage range -3000V – +3000V
Load current range static -2.5mA – +2.5mA
Load current range dynamic, t < 1ms -5mA – +5mA
Power bandwidth CL= 100pF, VO = 6000VPP,
THD ≤1%
DC – ≥1kHz
Bandwidth CL= 100pF, VO = 600VPP -3dB DC – ≥10kHz
Slew-Rate CL= 100pF ≥15V/μs
Internal output capacitance < 300pF
Ripple, Noise CL= 100pF; 1Hz – 20kHz ≤150mVRMS
Scaling monitor output V 10V V3000V ±1%
Bandwidth monitor output V DC – ≥20kHz
Scaling monitor output I 10V V10mA ±1%
Bandwidth monitor output I DC – ≥2kHz
-Signal ground and high voltage ground are connected to the chassis ground / earth terminal.
