Canadian Programming / Gate Programming
Canadian frequency laws, and the technology of some entry gates, require you to “cycle” (press and re-press the hand-
held transmitter button every two seconds) during programming.
Continue to press and hold the desired HomeLink button (note steps 3 through 5 in the “Programming” portion of this
text) while you “cycle” your hand-held transmitter until the frequency signal has been learned. The indicator light will
flash slowly and then rapidly upon successful training.
Note: When programming a garage door opener or gate, it is advised to unplug the device
during the “cycling” process to prevent possible motor burn-up
Operating the HomeLink®Universal Transceiver
To operate, simply press the programmed HomeLink button. Activationwill now occur for the trained product
(garage door, securitysystem, entry door lock, estate gate, or home or office lighting). For convenience, the hand-held
transmitter of the device may also be used at any time.
Rolling Code Programming
Rolling code garage door openers (or other rolling code devices) which are “code protected” and manufactured after
1996, may be determined by the following:
A. Reference the garage door opener owner’s manual for verification.
B. The hand-held transmitter appears to programthe HomeLink Universal
Transceiver but HomeLink does not activate the garage door.
C. Press and hold the trained HomeLinkbutton. The garage door opener has
the rolling code feature if the HomeLink indicator light flashes rapidly and
then turns solid after 2 seconds.
To train a garage door opener withthe rolling code feature, follow these instructions after completing the
“Programming” portion of this text (the aid of a second person may make the following training procedures quicker
and easier.)
1. Locate the training button on the garage door opener receiver (in the garage). Exact
location and color of the button may vary by garage door opener brand. If there is
difficulty locating the training button, reference the garage door opener owner’s
manual or contact HomeLink at 1-800-355-3515 or on the internet at
www.homelink.jci.com.
2. Press the “training” button on the garage door opener receiver (which will
activate the “training” light).
Note: Following step 2, there are 30 seconds inwhichto initiate step 3.
