Honeywell UMC800 Manuale utente

Form 51-52-33-100 Page 1 of 3

UMC 800

Operator Interface Disk Drive Assembly

Replacement Instruction

Disk Drive Assembly Kit (Part Number 51404557-501)

Document Number Form: 51-52-33-100

Effective: 6/98

Supersedes: None

Summary Enclosed is a new disk drive assembly for the Operator Interface (OI) of

your UMC 800 Controller. Use the following procedure to install it.

WARNING Never access components inside the operator interface with

power applied.

CAUTION This equipment contains devices that can be damaged by

electrostatic discharge. It is imperative that assemblies containing static-

sensitive devices be carried in conductive plastic bags. When adjusting or

performing any work on such assemblies, grounded work stations and

wrist straps must be used.

Tools Needed You will need a small Phillips-head screwdriver to perform this procedure.

Component Location Refer to Figure 1 for the location of the disk drive assembly and Table 1

for the installation procedure.

OI Housing Disk Drive

Assembly

Screws

(2 places)

J10

J3A

J3B

OI Housing

(Front Panel

Removed)

Figure 1 – Location of Disk Drive Assembly

Kit Instruction, continued

Page 2 of 3 Form 51-52-33-100

Replacement Follow the procedure in Table 1 to upgrade your operator interface to add

Procedure the floppy disk drive feature or to replace the disk drive assembly in the

OI.

Table 1 – OI Disk Drive Assembly Replacement. (Refer to Figure 1.)

Step Action

1Open the door on the righthand side of the OI unit. If OI is equipped with a disk drive,

press the button on the front to eject the diskette from the disk drive.

2Remove power from the operator interface by removing the cable from the back of the unit.

3Remove the front cover by removing two screws at the right, next to the disk drive.

See figure.

ALARM

ESC

1 5

⇐Screw

4Angle the right side of the front panel away from the unit and release it from the hinge at

the left.

5Unplug the following cables from connectors on the CPU board and remove the front panel.

a) OI display cable from J1.

b) Keypad cable from J2.

c) Twisted pair cable from J9.

6Remove two screws securing the disk drive assembly at the top and bottom of the OI

housing.

7Unplug the twisted pair cable from J3B of the CPU board. Carefully slide the disk drive

out of the housing.

8Unplug the following cables from the CPU board and remove the disk drive from the

housing:

a) The ribbon cable from J10.

b) The four-pin connector cable from J6.

Procedure continued on next page

Kit Instruction, continued

Form 51-52-33-100 Page 3 of 3

Table 1 – OI Disk Drive Assembly Replacement. (Refer to Figure 1.), continued

Step Action

9Install the ribbon cable and the power cable (supplied with kit) on replacement disk drive.

10 Plug in the disk drive ribbon cable to J10 on the CPU board.

Plug in the disk drive power cable to J6 (four-pin connector).

11 Carefully slide the disk drive into the OI housing. Plug in the twisted pair cable to J3B on

the CPU board.

12 Secure the disk drive to the housing at top and bottom with two screws.

13 Plug in the cables from the front panel to the following connectors on the CPU board:

a) Twisted pair cable to J9.

b) Flat ribbon cable to J2.

c) Gray ribbon cable to J1.

14 Reattach the front panel to the OI housing by hooking the tabs on the left side of the front

panel and securing it on the right side with two screws.

15 Plug in the DISPLAY cable from the controller into the OI connector at the rear of the

housing.

16 Power up the controller.

Look for start up screen.

Access the SELF-TESTS* screen under the Unit Menu.

Perform the KEYBOARD TEST and DISPLAY TEST to verify OI operation.

Open door on right side of OI front panel. Verify that display message reads “BEZEL

OPEN”.

17 Perform the DISK READ/WRITE TEST to verify OI operation.

* See UMC 800 Operator Interface User Guide, Document Number 51-52-25-62 for

more information on OI self tests and OI operation.

Altri manuali per UMC800

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Honeywell Controllori

Honeywell

Honeywell ML8824 Series Manuale dell'operatore

Honeywell

Honeywell ML7420A6025 Manuale utente

Honeywell

Honeywell Aquastat L7224U Manuale utente

Honeywell

Honeywell S9200U1000 Manuale utente

Honeywell

Honeywell HVC0001 Manuale utente

Honeywell

Honeywell 5 Nm Series Manuale operativo

Honeywell

Honeywell AQUASTAT L4188A Manuale utente

Honeywell

Honeywell LeakFilm MC Manuale utente

Honeywell

Honeywell Aquastat L4007 Manuale operativo

Honeywell

Honeywell UDC2800 Manuale utente

Honeywell

Honeywell ML7421A Manuale operativo

Honeywell

Honeywell HVC0001 Manuale utente

Honeywell

Honeywell UDC1200 MICRO-PRO Manuale utente

Honeywell

Honeywell MO953 Series Istruzioni per il montaggio

Honeywell

Honeywell RP920A-D Istruzioni per il montaggio

Honeywell

Honeywell 1000 Series Manuale utente

Honeywell

Honeywell RA116A Manuale utente

Honeywell

Honeywell C Manuale utente

Honeywell

Honeywell Air Alert 96d Manuale utente

Honeywell

Honeywell Ex-Or MLS2000DALIHBW Manuale di installazione e funzionamento

Honeywell

Honeywell VaporStat L408J Manuale utente

Honeywell

Honeywell UDC3500 Manuale utente

Honeywell

Honeywell ML6174 Series Manuale utente

Honeywell

Honeywell S05 Series Manuale operativo

Manuali Controllori popolari di altre marche

Digiplex

Digiplex DGP-848 Istruzioni operative

YASKAWA

YASKAWA SGM series Manuale utente

Sinope

Sinope Calypso RM3500ZB Manuale utente

Isimet

Isimet DLA Series Style 2 Manuale di installazione

LSIS

LSIS sv-ip5a Manuale utente

Rockwell Automation

Rockwell Automation 1769-L31 Manuale utente

Airflow

Airflow Uno hab Manuale utente

ABB

ABB ACS580-01 drives Manuale utente

Panasonic

Panasonic GM1 Series Manuale utente

Emerson

Emerson SW93 Manuale utente

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuale utente

Panasonic

Panasonic FP? Positioning Unit RTEX Manuale utente

Samson

Samson Type 5824 Manuale di servizio

Alpha IP

Alpha IP MIOB 21001 Manuale utente

Siemens

Siemens OpenAir GMA 1 Series Manuale utente

Surecom

Surecom SR-629 Manuale utente

Fishman

Fishman TriplePlay Manuale utente

Regulus

Regulus SRS1 T Manuale utente