Honeywell 5824 Manuale tecnico

5824 Serial/Parallel Printer Interface Module

Product Installation Document

PN 151392:G5 2/2/2022 151062

1 General

The 5824 Serial/Parallel Printer Interface Module connects a compatible

fire alarm control panel (FACP) directly to a printer to print event his-

tory, system event logs, and detector statuses. This document is for quick

reference. For more information, refer to the FACP installation manual.

2 Specifications

3 Mounting

The 5824 ships in a plastic enclosure which must be mounted inside the

annunciator or accessory cabinet.

To mount the 5824 plastic enclosure into the appropriate cabinet:

1. Remove the 5824 cover. Use a small screwdriver if necessary.

2. Remove the 5824 circuit board from the base by pushing outward

on the base snap retaining tabs and lifting out the circuit board.

3. Mount the plastic base into the appropriate accessory cabinet.

4. Replace the circuit board in the plastic base.

4 Wiring to a FACP

Terminate the wiring as shown in the diagram and table below.

NOTE: Installation and wiring of this device must be

done in accordance with NFPA 72 and local ordinances.

Operating Voltage 24 VDC

Current

(Alarm and Standby)

50mA

Max Per FACP Addressable FACPs qty 4; 5208 FACP qty 1

Operating Temperature 32°F to 120°F (0°C to 49°C)

Max Wiring Distance

from FACP

6000 ft. (1829 m)

Mounting Surface

Dimensions 6”W x 7-3/4”H x 1-7/16”D

(15.2 cm W x 19.7 cm H x 3.7 cm D)

Parallel Port Ancillary

Serial Port Primary Fire Signaling

NOTE: It may be necessary to connect the wiring to the

circuit board before the board is replaced into the base.

S- S+ AB

2345

snap retaining tabs

circuit board

base

Figure 1 5824 Circuit Board And Plastic Base

A B

S- S+ AB

– +

5824

FACP

SBus

Connector

- + A B

Figure 2 Wiring the 5824 to the FACP

25824 Installation Instructions — P/N 151392:G5 2/2/2022

5 Setting DIP Switches

Each 5824 connected to a compatible FACP requires an ID number

which is set using the DIP switches on the 5824 circuit board. Refer to

the figure below to see how to position the DIP switches for the desired

ID number. See the FACP installation manual for specific information on

device ID assignments. Note that address 0 is invalid and cannot be

used.

6 Connecting to a Printer

Cables are not supplied with the 5824. Use either a pass-through 9-pin

serial cable or a 25-pin Centronics®parallel cable to connect the 5824 to

the printer. Using the appropriate printer cable, connect the cable to the

serial or parallel port on the 5824, and then connect it to the printer.

5824 Terminals FACP SBUS Terminals

S+ +

S- –

Table 1 5824 to FACP Connections

123456 123456 123456

OFF

Address Address Address

Figure 3 DIP Switch Settings

Altri manuali Honeywell Portale

Honeywell

Honeywell Wireless Network Master ETH/WIFI T2 Manuale utente

Honeywell

Honeywell Experion PKS Manuale utente

Honeywell

Honeywell RFG100 Manuale utente

Honeywell

Honeywell Lyric LCP300-L Manuale di installazione e funzionamento

Honeywell

Honeywell Lyric LCP300-L Scheda informativa del prodotto

Honeywell

Honeywell Lyric LCP300-L Manuale utente

Honeywell

Honeywell GW-1000-WE Manuale utente

Honeywell

Honeywell NOTIFIER NFN-GW-PC-W Manuale utente

Honeywell

Honeywell NOTIFIER ONYXWorks NFN Gateway Manuale utente

Honeywell

Honeywell ESSER IQ8Wireless Gateway Manuale utente

Honeywell

Honeywell INNCOM PC-503 Manuale utente

Honeywell

Honeywell RedLINK THM6000R1002 Manuale utente

Honeywell

Honeywell CIU 888 Manuale utente

Honeywell

Honeywell OW-CDX050 Manuale utente

Honeywell

Honeywell NOTIFIER NFN-GW-PC-HNMF Manuale utente

Honeywell

Honeywell Notifier MODBUS-GW Manuale utente

Honeywell

Honeywell RedLINK THM6000R Manuale utente

Honeywell

Honeywell LCBS Connect Istruzioni operative e di manutenzione

Honeywell

Honeywell Notifier NFN-GW-EM-3 Manuale utente

Honeywell

Honeywell PEHA 940/8 DALI-G Manuale utente

Honeywell

Honeywell NFS-3030 Manuale utente

Honeywell

Honeywell ADPRO iFT Series Manuale utente

Honeywell

Honeywell 290092 Manuale utente

Honeywell

Honeywell GENT VIG-BNG Istruzioni operative e di manutenzione

Manuali Portale popolari di altre marche

LST

LST M500RFE-AS Manuale utente

Kinnex

Kinnex Media Gateway Manuale utente

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuale utente

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuale utente

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuale utente

Telsey

Telsey CPVA 500 - SIP Manuale utente

RTA

RTA 460A-NNA4 Scheda tecnica

Shaw

Shaw Gateway HDPVR Manuale utente

ABB

ABB VSN900 Guida rapida

Commander

Commander Pulse Manuale utente

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuale utente

NETGEAR

NETGEAR C6300BD Manuale utente

Amit

Amit CDW531AM Manuale utente

HMS

HMS Netbiter EasyConnect EC150 Manuale utente

Huawei

Huawei EchoLife HG620 Manuale utente

AT&T

AT&T U-verse 3801 Manuale per l'uso e la cura

Logic IO

Logic IO RTCU MX2 turbo Manuale utente

Suttle

Suttle MediaMAX MXM-521 Manuale utente