Honeywell Fire-Lite 2UD Manuale utente
2UD Modem Card
Mounting Instructions
The mIP-2 and the IPDACT-2 products can be converted to a mIP-2UD or to an
IPDACT-2UD (respectively) by installing the 2UD Modem Card. This will provide full
Alarm Panel Upload/Download support over the IP network.
Figure 1. Adding the 2UD modem card to a mIP-2 or an IPDACT-2 module
WARNING! Before proceeding with the installation, make sure all power
(AC and DC) has been removed.
The installer should follow the steps described below:
1. Remove the plastic label/cover from the IPDACT-2 Module. If the module is a mIP-2
this step may not be required.
2. Remove the jumpers from A and B pins located in the upper left portion of the mIP-2
or the IPDACT-2 module.
Dm395-Iv1 1
Figure 2. Close-up of pins A and B in mIP-2 and IPDACT-2 modules
3. Carefully align the connector on the 2UD Modem Card with the connector located in
the top left of the mIP-2 or the IPDACT-2 module and align the A and B connectors
on the 2UD Modem Card with the A and B pins on the mIP-2 or IPDACT-2 module
(jumpers removed in step 2).
Figure 3. Aligning the 2UD card with the mIP-2 or IPDACT-2 module
4. Carefully press the 2UD Modem Card onto the mIP-2 or IPDACT-2 module
connectors. Ensure that the 2UD Modem Card is securely seated, being careful not
to bend or break any pins on the connectors.
5. Reinstall the plastic label/cover on the IPDACT-2UD Module. If the module is a mIP-
2, this step may not be necessary.
Dm395-Iv1 2
6. Reapply all power (AC and DC) and test the system for proper operation.
Indice
Altri manuali Honeywell Modem
Honeywell
Honeywell CLOUDLINK 4G M1 Manuale utente
Honeywell
Honeywell Cloud Link 4G Modem Manuale utente
Honeywell
Honeywell XYR 400E Manuale utente
Honeywell
Honeywell Mercury Manuale utente
Honeywell
Honeywell XM500 Manuale utente
Honeywell
Honeywell E-Mon E10039 Istruzioni per il montaggio
Honeywell
Honeywell NPB-MDM Manuale utente
Honeywell
Honeywell HCI 300 Manuale utente
