HOOTBOOTH ILLUMIN8+ Manuale utente
HootBooth® ILLUMIN8+
Hardware Setup Guide
HootBooth ® ILLUMIN8+ Assembly Guide
2
1.
Attach lower pedestal piece to base plate using two tri-side thumb screws.
HootBooth ® ILLUMIN8+ Assembly Guide
3
2.
Attach upper pedestal piece to lower pedestal piece using 2 thumb screws.
HootBooth ® ILLUMIN8+ Assembly Guide
4
3.
Remove four thumb screws from back cover of top piece.
HootBooth ® ILLUMIN8+ Assembly Guide
5
4.
Pull cover aside. Remove 4 wing nuts and place iPad inside ensuring iPad orientation
is correct. Plug iPad charger into available outlet inside unit. Plug cable provided with iPad
into iPad. Bundle wiring neatly. Replace wing nuts and back cover
thumb screws. **See
noteatbottomregardingpotentialneedforadapter**
HootBooth ® ILLUMIN8+ Assembly Guide
6
5.
Mount half-circle bracket to the top of the unit using single thumb screw.
HootBooth ® ILLUMIN8+ Assembly Guide
7
6.
Mount top piece to half-circle bracket as shown below using two thumb screws.
Ensure the black plastic spacers are installed as shown.
7.
Plug power cable into wall outlet or extension cord and test that iPad is charging
and ring light is working.
HootBooth ® ILLUMIN8+ Assembly Guide
8
NOTE: There are a few versions (generations) of 11” Apple iPads. Older models
use a Lightning Connector
and newer models use a USB-C connector.
Newer Generations:
The cable provided with the iPad is a USB-C to USB-C and should plug in as shown
below:
Older Generations:
The older 11” iPad models used a lightning port. The Illumin8+ model you have uses a
USB-C receptacle. If you find the cable provided with your iPad does not fit into the
receptacle, you just need to purchase a USB-C to USB-A adapter such as this, also
pictured below:
Altri manuali HOOTBOOTH Attrezzatura di illuminazione
