HOVERBOARDHOVERBOARD
Powerbase
Starting up
* After successfull assembly and electric connection, start ignition of vehicle
and turn on the blue main switch.
* The compressor will fill the air supply tank to approx. 8,5 bar/120 psi
within about 2 minutes and the Hoverboard is ready.
* The Hoverboard works automatically --> when the air pressure
has lowered to approx. 8 bar/115 psi, the compressor starts automatically
for approx. 20 seconds again. This allows constant operating pressure.
* By turning off the ignition or the blue main switch, the hoverboard automatically
lowers for loading and unloading.
It also lowers when you unlock the PowerLoad on the hoverboard.
* During regular air suspended drive, the red toggle switch (option) is set off.
For lifting the Hoverboard to highest position (e.g. for reanimation) switch it on.
ATTENTION:
When lifting to the highest position, the compressor runs continuously for approx. 3 minutes.
Multiple lifting in short intervals will overheat the compressor ! The thermal protection switch
will turn off the compressor and needs approx. 1 hour to cool down !
* By pushing one of the pushbuttons, the lateral movement device (option)
will unlock pneumatically. While keeping pushed, you can sway the Hoverboard
crosswise in 8 positions of 32 mm / 1,25" (total = 256 mm / 10").
Releasing the button means locking in the nearest position.
This option also works with ingition off.
In case of malfunction or lack of air pressure you may unlock it by the knobs.
* For correct loading and unloading please refer to the instructions of the stretcher.
Please pay attention to the correct locking of the stretcher on the Hoverboard.
HOVERBOARD
Have always a good trip with your new
Top position
on/off
Suspension
on/off
Unlock lateral
movement device
