HP V24i G5 Manuale
Maintenance and Service Guide
V24i G5 model
SUMMARY
This guide provides information about spare parts, removal and replacement of parts, diagnostic tests, problem
troubleshooting, and more.
© Copyright 2022 HP Development
Company, L.P.
AMD is a trademark of Advanced Micro
Devices, Inc. Bluetooth is a trademark owned
by its proprietor and used by HP Inc. under
license. NVIDIA is a trademark and/or
registered trademark of NVIDIA Corporation
in the U.S. and other countries. USB Type-C
and USB-C are registered trademarks of USB
Implementers Forum. DisplayPort and the
DisplayPort logo are trademarks owned by the
Video Electronics Standards Association
(VESA) in the United States and other
countries.
The information contained herein is subject to
change without notice. The only warranties
for HP products and services are set forth in
the express warranty statements
accompanying such products and services.
Nothing herein should be construed as
constituting an additional warranty. HP shall
not be liable for technical or editorial errors
or omissions contained herein.
First Edition: Jun. 2022
Document Part Number: N08474-V24i G5-
MSG-V1
Assembly part number: N08474-001
Product notice
Only trained service personnel familiar with
this product should service it. Before
performing any maintenance or service, be sure
to read “Important Safety Information”.
1
Table of Contents
1Getting started........................................................................................................................................................................2
Important safety information ...........................................................................................................................................2
Important service information and precautions ................................................................................................................2
RoHS (2002/95/EC) requirements....................................................................................................................................3
General descriptions ........................................................................................................................................................3
Firmware updates.............................................................................................................................................................3
Before returning the repaired product to the customer ....................................................................................................3
2Monitor features.....................................................................................................................................................................4
Features............................................................................................................................................................................4
Front components.............................................................................................................................................................5
Rear components..............................................................................................................................................................6
Locating the serial number and product number..............................................................................................................7
3Illustrated parts catalog..........................................................................................................................................................8
How to order parts .........................................................................................................................................................10
4Removal and replacement procedures..................................................................................................................................11
Preparation for disassembly...........................................................................................................................................11
Rear Cover.....................................................................................................................................................................11
Power board...................................................................................................................................................................16
Connector repair ............................................................................................................................................................17
DP connector CN501..........................................................................................................................................19
HDMI connector CN502....................................................................................................................................20
D-SUB connector CN503...................................................................................................................................21
Function test...................................................................................................................................................................22
Function test...................................................................................................................................................................22
Support and troubleshooting..........................................................................................................................................22
Index..............................................................................................................................................................................24
2
1Getting started
Read this chapter to learn about safety information and where to find additional HP resources.
Important safety information
Carefully read the cautions and notes within this document to minimize the risk of personal injury to service
personnel. The cautions and notes are not exhaustive. Proper service methods are important to the safe, reliable
operation of equipment. Improper service methods can damage equipment.
The service procedures recommended and described in this service manual provide effective methods of
performing service operations. Service engineers should have prior repair knowledge and experience as well as
appropriate training for the product before performing service procedures.
●Be sure your working environment is dry and clean and meets all government safety requirements.
●Be sure that other persons are safe while you are servicing the product.
●Do not perform any action that can cause a hazard to the customer or make the product unsafe.
●Use proper safety devices to ensure your personal safety.
●Always use approved tools and test equipment for servicing.
●Never assume the product’s power is disconnected from the main power supply. Check that it is
disconnected before opening the product’s cabinet.
●Modules containing electrical components are sensitive to electrostatic discharge (ESD). Follow ESD
safety procedures while handling these parts.
●Some products contain more than one battery. Do not disassemble or expose a battery to high
temperatures, such as throwing into fire, or the battery may explode.
●Refer to government requirements for battery recycling or disposal.
This information provides general service information for the monitor. Adherence to the procedures and
precautions is essential for proper service.
IMPORTANT: Only trained service personnel who are familiar withthis HP product should performservice or
maintenance for it. Before performing any service or maintenance, personnel must read the important safety
information.
IMPORTANT: You must disconnect the power cord from the power source before opening the monitor to
prevent component damage.
Important service information and precautions
●Repair must be performed by professional service technicians in a repair center. End users should not
perform these procedures.
●Please note during servicing that the primary side is the high voltage area.
●This monitor meets ROHS requirements. Be sure to use lead-free solder wire when soldering.
●If you must change a capacitor, be sure to match the polarity as printed on the PCB.
●If you must replace a capacitor, make sure the specification and part number match the BOM and
location.
●If you must replace a capacitor, insert new parts carefully to avoid a short circuit caused by the near
pin.
●Do not get the board wet. Water and moisture can cause a short circuit that causes malfunctions.
3
●To avoid damage, be sure to use lead-free solder.
●When soldering, work quickly to avoid overheating the circuit board.
●Keep the soldering iron tip clean and well tinned when replacing parts.
●After repair, perform a close inspection of the circuit board to confirm it is in good condition.
●After repair, perform a function test to confirm the power supply is working properly.
ERP Lot5 requirement
1. A professional repairer must have the technical competence to repair electronic displays and comply
with the applicable regulations for repairers of electrical equipment in the Member States where the
repairer operates. Reference to an official registration system as professional repairer, where such a system
exists in the Member States, shall be accepted as proof of compliance.
2. A professional repairer must have insurance that covers liabilities resulting from repairs, regardless of
whether required by the Member State.
RoHS (2002/95/EC) requirements
Applied to all countries that require RoHS.
The RoHS (Restriction of Hazardous Substance in Electrical and Electronic Equipment Directive) is a legal
requirement by the EU (European Union) for the global electronics industry sold in the EU and other countries.
Any electrical and electronics products launched in the market after June 2006 should meet this RoHS
requirement. Products launched in the market before June 2006 are not required to be compliant with RoHS
parts. If the original parts are not RoHS complaint, the replacement parts can be non-ROHS complaint. If the
original parts are RoHS compliant, the replacement parts MUST be RoHS complaint.
If product service or maintenance requires replacing parts, confirm the RoHS requirement before replacement.
General descriptions
This manual contains general information. There are two levels of service:
Level 1: Cosmetic/appearance/alignment service
Level 2: Circuit board or standard parts replacement
Firmware updates
Firmware updates for the monitor are available at support.hp.com. If no firmware is posted, the monitor does
not need a firmware update.
Before returning the repaired product to the customer
Perform an AC leakage current check on exposed metallic parts to be sure the product is safe to operate
without the potential of electrical shock. Do not use a line isolation transformer during this check.
Measurements that are not within specified limits present a possible shock hazard. You must check and repair
the product before returning it to the customer.
4
2Monitor features
This chapter provides an overview of the monitor’s features.
Features
Depending on the model, your monitor might include the following features:
Displayfeatures
●60.45 cm (23.8 in) plus full-screen support for lower resolutions; includes custom scaling for maximum image size
while preserving original aspect ratio
●Liquid crystal display (LCD) with active matrix and in-plane switching (IPS) (select products only)
●sRGB color gamut
●Nonglare panel with an LED backlight
●
Tilt capabilities
●Height adjustment capabilities (select products only)
●On-screen display (OSD) adjustments in several languages for easy setup and screen optimization
●Energy saver feature to meet requirements for reduced power consumption
●Security cable slot on the rear of the monitor for an optional security cable
●Cable management feature for placement of cables and cords
●Speakers are available on select models only
Connectors
●VGA port (select products only)
●DisplayPort™ video input (select products only)
●High-Definition Multimedia Interface™ (HDMI™) video input
●USB Type-C® port (select products only)
●Plug and Play capability, if supported by your operating system Monitor
stand
●Removable stand for flexible monitor head mounting solutions
●VESA® mounting capability (100 ×100 mm) for attaching the monitor to a swing arm mount
●Support for a mounting bracket to attach the monitor to a workstation
NOTE: For safety and regulatory information, see the Product Notices provided in your documentation kit. To access the
latest user guide, go to http://www.hp.com/support, and follow the instructions to find your product. Then select Manuals.
5
Front components
To identify the components on the front of the monitor, use this illustration and table.
Table 1-1: Front components and their descriptions
Component
Function
1
Power LED
Indicates that the monitor is powered on.
2
Power button
Turns the monitor on or off.
NOTE: Be sure that the master power switch on the
monitor is in the On position to turn on the monitor.
(Select products only.)
6
Rear components
To identify the components on the rear of the monitor, use this illustration and table.
Table 1-2: Rear components and their descriptions
Component
Function
1
Joypad OSD button
Opens the OSD settings.
2
Security cable slot
Connects an optional security cable.
3
Power connector
Connects a power cord.
4
DisplayPort connector
Connects a DisplayPort cable to a source device
such as a computer or game console.
5
HDMI port
Connects the HDMI cable to a source device
such as a computer or game console.
6
VGA port
Connects a VGA cable to a source device such as
a computer or game console.
4
Menu button
Press to open the OSD menu.
5
Security cable slot
Connects an optional security cable.
6
Power connector
Connects a power cord.
7
Locating the serial number and product number
The SPEC label (1) and Barcode label (2) are located on the rear of the monitor. The serial number and product
number are located on a Safety label. You may need these numbers when contacting HP about the monitor model.
Barcode label
Spec label
8
3Illustrated parts catalog
To identify the monitor major components, use this illustration and table.
Item
Description
Qty
1
DECO_BEZEL L238W-Fhp1-s1
1
2
LENS
1
3
LCD M238HAN03.10Y SZ AUO
1
4
MIDDLE_FRAME L238W-Fhp1-s1
1
5
INSULATING SHEET 125.7*92.9*0.5mm
1
6
ADAPTER BOARD
1
7
MAINFRAME
1
8
KEY BOARD
1
9
KEY
1
10
KEY_FUNCTION
1
11
KEY_POWER
1
12
stand ass''y NA NA
1
13
BASE_ASS’Y NA N/A
1
14
COVER_VESA L238W-Fhp1b-s1
1
15
REAR_COVER L238W-Fhp1b-s1
1
Indice
Altri manuali HP Monitor
HP
HP W1707 - 17" LCD Monitor Manuale utente
HP
HP Compaq LE2002x Manuale utente
HP
HP M900 Manuale utente
HP
HP EliteDisplay S270n Istruzioni per l'installazione
HP
HP L2245wg Manuale utente
HP
HP E24i G4 HO Istruzioni per il montaggio
HP
HP Pavilion M703 Manuale utente
HP
HP L1925 - 19" LCD Monitor Manuale utente
HP
HP V192B.BHP Manuale utente
HP
HP TFT7210R Manuale utente
HP
HP 2159v Manuale utente
HP
HP L717g Istruzioni per l'installazione
HP
HP V192b Istruzioni per l'installazione
HP
HP Z24m G3 Manuale
HP
HP Invent LP2065 Manuale utente
HP
HP Compaq LA1951G Istruzioni utente
HP
HP N240 Manuale utente
HP
HP WC292AA#ABA Manuale utente
HP
HP D8897 Series Guida di riferimento
HP
HP 25mx Manuale
