HP 6100 Guida

HP StorageWorks

Operator ControlPanel

replacement instructions

These instructions apply to the EVA4x00/6x00/8x00

products. The part may also be used in other HP

products. See the documentation for your product for

detailed replacement instructions.

L.P.

Third edition June 2007

The information in this document is subject to change without

notice.

Printed in Puerto Rico

www.hp.com

*5697-6792*

About this document

This document describes the procedure for replacing the Operator

Control Panel (OCP).

CAUTION:

This procedure assumes the storage system is running XCS 6.000

orlater.IfyouarerunninganearlierversionofXCS,contactyour

HP-authorized service representative for assistance in replacing

the OCP.

Warranty information

Iftheproductinwhichthispartisbeingreplacedisstillunder

HP warranty, then the replacement part(s) referred to in these

Replacement Instructions is provided under the terms and conditions

of the Hewlett-Packard Company Limited Warranty for that

product. A copy of this Limited Warranty may be viewed at:

http://h18006.www1.hp.com/products/storageworks/warranty.html

If this is a trade sale part (product out of warranty), then the replacement

part(s) referred to in these Replacement Instructions is provided under

HP's express limited warranty statement, which may be viewed at:

http://customerops.corp.hp.com/1sw/pdm_om/warranty_support/

policies/2330100.doc

The replacement part takes on either the Limited Warranty Period of the

part being replaced or a ninety-day period that begins upon installation

of the replacement part, whichever is greater.

The only warranty for this replacement product is as noted above.

Nothing in these replacement instructions should be construed as

constituting an additional warranty. The information provided in these

replacement instructions is provided "AS IS" and HP is not liable for

technical or editorial errors or omissions contained herein.

Before you begin

Observe the following precautions when replacing the OCP:

•Removing the OCP signiﬁcantly changes the air ﬂow within the

enclosure. The OCP must be installed for the enclosure to cool

properly. If the OCP fails, leave it in place in the enclosure until a

new OCP is available to install.

•Parts can be damaged by electrostatic discharge. Use proper

anti-static protection.

•UsecarewhenreplacingtheOCPtoavoiddamagingtheenclosure.

Removing the OCP

1. Remove the front panel (1, Figure 1) by grasping the panel at each

end pulling it off the enclosure.

2. Press the OCP latch (2) and swing the panel out until it is fully open.

CAUTION:

Handle the OCP by its metal frame only. This will ensure that the

electronic components are not damaged by static discharge.

3. Grasp the OCP by its metal frame and pull it out of the enclosure

(3).

Page 1

0142b

Figure 1 Removing the OCP

Installing the OCP

1. Slide the new OCP into the enclosure (1, Figure 2).

2. Close the OCP until the latch engages.

3. Install the front panel, pressing it ﬁrmly into place.

NOTE:

After installing the OCP, the controller may have to upgrade the

OCP ﬁrmware. Do not remove the OCP while this operation is in

progress. When the OCP is displaying the alternating Storage

System Name and WWID, the correct ﬁrmware has been loaded

on the OCP.

0143b

Figure 2 Installing the OCP

Verifying proper operation

After replacing the OCP, verify that it is operating properly:

1. Check the display. It will typically display the default information

which alternates between the Storage System Name and the World

Wide Name.

2. Press any push button. The Storage System Menu Tree should be

displayed.

Returning the failed component

Follow the return instructions provided with the new component.

Page 2

Altri manuali per 6100

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali HP Magazzinaggio

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Manuale di istruzioni

HP 6400/8400 Guida rapida

HP StorageWorks TL895 Manuale utente

HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard... Manuale

HP StorageWorks 1500cs - Modular Smart Array Manuale utente

HP StorageWorks 7100 - Virtual Array Guida rapida

HP StorageWorks 7110 - Virtual Array Guida rapida

HP StorageWorks SDLT 600 Guida all'installazione

HP StorageWorks P4000 Series Manuale di istruzioni

HP P5389A - Intel Pentium III-S 1.4 GHz Processor... Manuale utente

HP 500 G2 Guida all'installazione

HP StorageWorks XP1024 Manuale utente

HP StorageWorks MSL6000 series Manuale utente

HP 6400/8400 Manuale utente

HP MSA 1050 Manuale di programmazione

HP P9000 Manuale utente

HP 6000 SERIES Istruzioni per il montaggio

HP StorageWorks 7110 - Virtual Array Manuale utente

HP P9000 Manuale utente

HP Q153090901 Manuale del prodotto

HP StorageWorks 70 Come usare

HP StorageWorks XP10000 - Disk Array Manuale utente

HP NetStorage 6000 Manuale di installazione e funzionamento

HP Cisco MDS 9020 - Fabric Switch Manuale utente

Manuali Magazzinaggio popolari di altre marche

QNAP

QNAP TS 32PXU Series Manuale utente

LaCie

LaCie RUGGED RAID Manuale utente

Freecom

Freecom CLS DOCK Manuale utente

PNY

PNY Attache P-FD64MBATT3 Manuale utente

OLT

OLT 6x6 Maximizer Manuale utente

Transcend

Transcend JetFlash 160 Manuale utente

LaCie

LaCie RUGGED MINI Manuale utente

Thunderbolt

Thunderbolt 600 Manuale utente

Panasonic

Panasonic LB-DH8 series Manuale

Intel

Intel RAID High Availability Manuale utente

LaCie

LaCie 12big Thunderbolt 3 Manuale utente

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuale utente

Panasonic

Panasonic LKM-F931-1 Manuale utente

Tabernus

Tabernus Enterprise Erase E2400 Manuale utente

Rocstor

Rocstor COMMANDER 3F series Manuale utente

Western Digital

Western Digital Ultrastar Data60 Manuale utente

Dell

Dell PowerVault MD3600f Series Manuale utente

CFI

CFI TERA STOR SATA RAID IV Manuale utente