09
In the screen showing the battery voltage, hold down
"BATTERY TYPE" for approximately 3-5 seconds
before the screen flashes the current battery type. Once
flashing, use the"AMP/VOLT" button to highlight LI.
4. Select Lithium Battery Voltage and Charge Voltage
BATT.
TYPE
Please note if choosing a 24V LI battery setting, the boost
charging voltages will still be shown in their 12V values. Multiply
the value by 2 to find out 24V charging voltage.
NOTE
Once LI is flashing, tap the "BATTERY TYPE"
button and a 12V will flash in the screen.
If you want 12V LI charging, then select the "BATTERY TYPE" again to move to LI
Boost Charging Voltage. If you want a 24V LI charging, then you select
"AMP/VOLT"to move from 12V to 24V LI Charging. Once you confirm your LI
Charging (12V or 24V) press "BATTERY TYPE" to move to LI Boost Charging
Voltage.
Press “AMP/VOLT” to change the Boost Voltage. The default setting is 14.2V
and the user can set it in the range 12.6~16.0V, in 0.2V increments. Once
done, hold “BATTERY TYPE” to confirm the selection. The setting will also be
automatically save after 15 seconds without holding “BATTERY TYPE”.
V
12V
BATT.
V
12V
CHG
BATT.
System Status Icons
Flashing: The bars are sequencing, indicating the
controller is activating over-discharged lithium battery.
Icon Behavior
Constant: System is normal, but it is not charging
Charging: The bars will be sequencing indicating the system is charging.
Constant: The battery is at full charge.
Flashing: The battery is overvoltage.
Flashing: The battery is under voltage.
Constant: System error.
