NGN Cases Table of Contents
Confidential Information of Huawei. No Spreading without Permission
ii
2.7 Pause Point in the Program Caused by the Loss of the UDP Fragment in the Multicast
Service of the Smart MA5600T................................................................................................. 31
2.8 Smart MA5600T NTP time problem caused synchronized time abnormally................. 32
2.9 Smart MX 5600T PPP use cannot get IP cause by BAS malfunction........................... 33
2.10 FAQ-How to Connect and Configure the Humidity Sensor in the H304ESC................ 34
2.11 FAQ- Why configurations are lost when using save configuration command............... 34
2.12 FAQ-why we can not get the same value of SNR margin use the same line-profile in the
same physical-line. ................................................................................................................... 36
2.13 FAQ-What is the maximum number of line-profile and line-template that can be defined
in MA5600T............................................................................................................................... 37
2.14 FAQ-How to Select the Correct Frequency Spectrum Profile During the Configuration of
the VDSL2 Line Profile ............................................................................................................. 38
2.15 FAQ-What Is by Default the Running Mode of the Fan of the MA5606T...................... 39
2.16 FAQ-How to config dynamic and static Multicast program at MA5606T....................... 39
2.17 FAQ-How to find out the reason for unable to call certain numbers via SIP................. 40
2.18 FAQ-What is difference between ADSL mode and NGADSL mode............................. 41
Chapter 3 GPON FTTx Cases..................................................................................................... 42
3.1 How to enable MA5680T ETHB Port to connect to other vendor's equipment............. 42
3.2 256 multicast channels can't be online at the same time in 5680T............................... 42
3.3 The Matching Status of the ONT and the Profile Is 'Mismatch' Because the Numbers of
the GEM Ports Supported by the MA5680T and the MA5626G Are Different......................... 43
3.4 The Voice Communication on the MA5606T Is Unidirectional Because of the Routing
Problem of the Media Stream................................................................................................... 44
3.5 FAQ-How to Perform Inter-Board Mirroring on the Upstream Board on the MA5680T 45
3.6 FAQ-How to Implement the Interworking Between Different FE Ports on the MA562xG46
3.7 The Interconnection Between the Switch of Company C and MA5600T Fails Because
the LACP Configuration of the Switch of Company C Is Incorrect........................................... 46
3.8 FAQ-How to Change the Default T-CONT 0 Type of the MA5600T Providing the GPON
Service...................................................................................................................................... 47
3.9 THE GICF Board Is in the config State and the Service Cannot Recover After the
MA5680T Is Restarted.............................................................................................................. 47
3.10 The MA5620G Plays the Busy Tone After Offhook Because of Incorrect Descriptor
Signaling Delivered by the Softswitch of company x................................................................ 47
3.11 AQ-How to Calculate the Actual Split Ratio when the xPON Uses the Multi-level Optical
Splitting Mode........................................................................................................................... 47
3.12 Users Connected to the MA5620G Cannot Make Calls Normally After Taking the
Phone off the Hook Because RTP Resources of the Softswitch Are Allocated Insufficiently .. 47
3.13 FAQ-How to Configure the ACL Rule on the MA5680T So That the Priority of the Outer
VLAN Can Be Changed Based on the Inner VLAN Tag........................................................... 47
3.14 All ONTs (HG850s) Connected to a PON Port Get Online and Offline Frequently
Because One of the ONTs Connected to the PON Port Is Faulty............................................ 47
3.15 The ONT Connected to the MA5680T Goes Offline Frequently Due to the Incorrect
Connection of Optical Fibers on the Optical Splitter................................................................. 47
3.16 Users Fail to Log In to the Server from the N2000 BMS Client Because of the Incorrect
Setting of the Client................................................................................................................... 47
3.17 FAQ-How to Implement the VoIP Service of the MA5680T.......................................... 47
3.18 The FE Port Cannot be Activated After the HG810e Connected to the MA5680T Is
Powered Off Because the ONT Profile Does Not Match the ONU Profile................................ 47
3.19 A Port of the H813e Cannot Forward Packets Normally Because the Native VLAN of
the Port Is the Same as the Multicast VLAN ............................................................................ 47
