Hubsan X4 Star Manuale utente

ITEM NO.: H502C

ARM/DISARM MOTORS, SEE PAGE 06

RTH FUNCTION, SEE PAGE 09

COMPASS CALIBRATION, SEE PAGE 12

TRANSMITTER CALIBRATION, SEE PAGE 13

Ages 14+

READ THE INSTRUCTION MANUAL CAREFULLY

PLEASE VISIT WWW.HUBSAN TO UPGRADE

HUBSAN X4 STAR

IMPORTANT SAFETY NOTES

OPERATION:

Flight:

Take responsiblity for the safety of yourself and others when flying the X4!

Do not fly the X4 in crowded places.

Do not fly in bad weather.

Never try to catch the X4 while it is in flight.

This model is intended for experienced pilots age 14+.

Power off the X4 after flight, to prevent the propellers from causing injuries.

Always remove the battery after you stop flying to avoid injuries from accidentally

powering on the motors.

Always take great caution to protect yourself when near the propellers.

The flight system will start after powering on regardless of the transmitter signal. The high

speed propellers are very dangerous.

Power off the X4 after every flight or the propellers may still rotate and cause injury.

Hubsan X4 Star

2016.04

Please read the instruction manual carefully!

V1.0

Be extremely careful and responsible when using the drone. Small electronic components can

be damaged by crashing or by dropping the X4 into water. To avoid further damages, please

replace broken parts immediately.

INTRODUCTION

1. ITEMS INCLUDED IN THE BOX

Check all the items in the box before using.

S/N Part Name Photos Q'ty Remarks

1 Quad copter 1PC Equipped with smart flight

controller,GPS and compass

Propeller A 4pcs, Propeller

B 4pcs

2 Propellers 8PCS

6 Screw-driver 1PC For removing propellers

47.4V Li-Po battery 1PC For quad copter

Transmitter (powered by

4 X AAA battery-Not included)

3 Transmitter 1PC

Thank you for buying the HUBSAN product. It is designed as an

easy-to-use,multi-functional RC model, capable of hovering and acrobatic ﬂight

maneuvers. Please read the manual carefully and follow all the instructions. Be

sure to keep the manual for future reference.

7 2PCS Disclaimer

Hubsan X4 Instruction Manual

User Manual

5 1PCUSB Charger For Li-Po battery charging

Quadcopter Weight: 147g(including battery)

Please fully charge the batteries to avoid loss of control due to low voltage.

Risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteries according to the local regulations.

2. QUAD COPTER MOTOR LED INDICATOR

3. QUAD COPTER BATTERY

3.1 INTRODUCTION

The quad copter battery is a rechargeable Li-Po battery with 450mAh capacity and 7.4V voltage.

The battery should only be charged with the HUBSAN charger to avoid overcharge.

3.2 INSTALL THE BATTERY

Push the battery into the battery compartment

correctly.

Please make sure the battery is fully charged before first time use.

Indicator Status:

Front LED: is blue; Back LED: is red.

1. Power on: 4 LED indicators blink simultaneously every 1.5 seconds.

2. Compass Calibration:

1). Horizontal calibration: 4 LED indicators blink circularly.

2). Vertical calibration: 4 LED indicators blink alternately.

3. GPS Flight: 4 LED indicators remain lighted.

4. GPS Return : 2 front LED remain lighted, and 2 back LED blink twice every second.

5. Photo: 2 front LED remain lighted, 2 back LED blink once.

6. Video: 2 front LED remain lighted, 2 back LED blink alternately.

7. LED indicators can be turned off when taking pictures and videos.

3.3 CHARGING

Connect the battery to the USB charger, then connect the USB charger to USB devices,

such as a computer or mobile power charger.

It takes around 110 minutes to fully charge the battery with 460~495mA current. The USB

LED indicator blink slowly in red when charging and will remain lighted when the battery

is fully charged. Please unplug the charger and battery when the charging is completed.

4. PROPELLER

Match the “I” mark on propellers to the “D” gap on

motor shafts when assembling, as figure 1 shows.

Attach the propellers to the corresponding motors that

are marked A and B,tighten the propellers and keep the

motors deadlocked with the screw-driver.

● Hazardous moving parts keep fingers and other body part away.

● Make sure that the A and B propellers are installed correctly. The X4 will not fly if

propellers are improperly installed.

“I” Mark

“D”Gap

5.1 FLIGHT ENVIRONMENT

(1) The flying area should be open and without tall buildings or other obstacles; the steel

structure within buildings interferes the compass and the GPS signal.

(2) DO NOT fly in bad weather such as strong wind, heavy snow, rain or fog.

(3) Keep away from barriers, people, power cables, trees, and other obstructions.

(4) Do NOT fly near radio towers or airports.

(5) The X4 control system will not work properly at the South or North Pole

(6) DO NOT fly in restricted areas and obey your country's laws and regulations.

5. START TO FLY

5.3 ARM/ DISARM THE MOTORS

Arm the motors

Method : Pull the left stick to the left lowest corner and the right

stick to the right lowest corner as the picture shows. Release

both sticks after the motors are armed.

Disarm the motors

Method : Pull the left stick to the left lowest corner and the right

stick to the right lowest corner again, and release both sticks after the motors are disarmed.

Do not stop the motors during the flight to avoid crashing.

Push the sticks lightly. Release the sticks after the motors are armed or disarmed.

High Tension Line RainInterferenceAirport

5.2 BINDING

The binding is completed in factory.

For re-binding, press Photo/Video button and power on the transmitter until “H” displayed, then

power on the drone, and place it very close to the transmitter, the binding will be completed after

one “ beep” heard.

Should the binding failed, please power off the drone and repeat above steps.

5.4 BASIC FLIGHT

Transmitter (Model 2) X4 Remarks

The operation mode for the transmitter including Mode 1 or Mode 2. The manual will use Mode 2 as

an example to illustrate the transmitter’s operation.

The throttle stick controls the ascent and

descent .

Push up the stick and the X4 will ascend.

Pull down the stick and the X4 will descend.

When the stick is in the center, the X4 will hover

and hold its alititude automatically .

Move the throttle stick above the center position

to take off. (Move the stick slowly to prevent the

X4 from ascending too quickly.)

Down

The Rudder stick controls the rotate direction .

Push the stick left and the X4 will rotate

counter-clockwise.

Push the stick right and the X4 will rotate

clockwise.

When the stick is in the center,the X4 will keep

the current direction and not rotate.

Pushing harder will cause the X4 to rotate

faster in the corresponding directions.

Right rotation

Left rotation

Forward

Backward

Right

Left

The Elevator stick controls the X4 forward and

backward.

Push the stick up and the X4 will fly forward.

Pull the stick down and the X4 will fly

backward.

When the stick is in the center, the X4 will hold

its position.

The angle of stick movement corresponds to

the angle of tilt and flight speed.

The Aileron stick controls the left and right flight.

Push the stick left and the X4 will fly to the left.

Push the stick right and the X4 will fly to the

right.

The X4 should be horizontal and keep the

current status when the stick is in the center.

The angle of stick movement corresponds to

the angle of tilt and flight speed.

Insert the SD card into quadcopter before using Photo/Video function.

Press the Photo/Video button for 0.5 second to take photos.

Press the Photo/Video button for 1.5 seconds to take videos and press again to save the videos.

5.5 PHOTO / VIDEO

Stop recording before the SD card is removed.

PHOTO / VIDEO

6.1 GPS POSITIONING/ HOME POINT SETTING

1.) GPS Positioning works ONLY when the GPS signal has no less than 6 satellites.

2.) Home Point is recorded when armed the motors with no less than 6 GPS satellites.

3.) You should be in an open place to search for the GPS satellites, it’ll take 3 mins to finish

the searching, and the GPS signal strength depends on the flying environment.

6. ADVANCED PERFORMANCE SETUP

Set

RTH only available when there are no less

than 6 GPS satellites displayed on transmitter.

Press the RTH for 1.5 seconds to activate the

function, press again to stop the RTH.

GPS and RTH function only available outdoors.

RTH

6.3 FAILSAFE MODE

The drone will enter into Failsafe Mode when the connection is lost from the transmitter. The

flight control system will control the quad copter to return to the home point and land

automatically. The Failsafe Mode helps to avoid further injuries or damages.

CONDITIONS WHICH ACTIVATE THE FAILSAFE MODE

(1) Transmitter is powered off.

(2) The flight distance is beyond the range of the transmitter’s signal transmission.

(3) The transmitter’s signal was interrupted by some other strong electronic interference.

To ensure that the X4 can return safely to its home point when GPS signal is lost, fly

the X4 in safe flight area.

If the quantity of GPS satellites drops below six for more than 20 seconds while the

X4 is returning home, the X4 will descend automatically.

The X4 will not avoid obstacles automatically while in failsafe mode.

!The RTH MODE only works when the GPS with no less than 6 satellites.

6.2 RTH MODE

ENTER/ EXIT RTH MODE

Press the RTH button for 1.5 secondS, and the drone will enter into RTH mode. The flight control

system will control the drone to fly back to the home point and land automatically. Press the

button again for 1.5 seconds to exit RTH mode.

(RETURN TO HOME)

Questo manuale è adatto per i seguenti modelli

Altri manuali Hubsan Quadricottero

Hubsan

Hubsan X4 CAM PLUS H107C+ Manuale utente

Hubsan

Hubsan NANO Q4 SE Manuale utente

Hubsan

Hubsan X4 DESIRE Manuale utente

Hubsan

Hubsan X4 DESIRE Manuale utente

Hubsan

Hubsan X4 Pro FPV Manuale utente

Hubsan

Hubsan X4 DESIRE Manuale utente

Hubsan

Hubsan NANO Q4 SE Manuale utente

Hubsan

Hubsan X4 FPV QUADBRUSHLESS Manuale utente

Hubsan

Hubsan X4 DESIRE Manuale utente

Hubsan

Hubsan X4 DESIRE H502S Manuale utente

Hubsan

Hubsan X4 DESIRE Manuale utente

Hubsan

Hubsan FPV X4 H107D Manuale utente

Hubsan

Hubsan X4 DESIRE H502S Manuale utente

Hubsan

Hubsan H107 Manuale utente

Hubsan

Hubsan ZINO PRO Manuale utente

Hubsan

Hubsan X4 FPV BRUSHLESS Manuale utente

Hubsan

Hubsan X4 DESIRE Manuale utente

Hubsan

Hubsan X4 H107P Manuale utente

Hubsan

Hubsan X4 FPV QUADBRUSHLESS Manuale utente

Hubsan

Hubsan FPV RTF Manuale utente

Hubsan

Hubsan X4 Pro FPV Manuale utente

Hubsan

Hubsan X4 Pro FPV Manuale utente

Hubsan

Hubsan X4 FPV BRUSHLESS Manuale utente

Hubsan

Hubsan X4 DESIRE Manuale utente

Manuali Quadricottero popolari di altre marche

dji

dji MAVIC 2 PRO Manuale utente

Autel Robotics

Autel Robotics EVO II Dual 640T Manuale utente

Carson

Carson X4 NANO Manuale utente

Attop

Attop W80 Manuale utente

Alias

Alias 6608 Manuale utente

Reely

Reely Drone Copter 2-in-1 Manuale utente

Falcon

Falcon S2-210 Manuale utente

Kaiser Baas

Kaiser Baas KBA15007 Manuale utente

Denver Electronics

Denver Electronics DCH-261 Manuale utente

Craig

Craig INTERCEPTOR Manuale utente

Odyssey

Odyssey TURBO RUNNER Manuale utente

IMAGINARIUM

IMAGINARIUM droni stream Manuale utente

AR.Drone

AR.Drone Parrot VSM Manuale utente

Walkera

Walkera QR X900 Manuale utente

dji

dji Phantom 2 Vision + Manuale utente

HobbyZone

HobbyZone Zugo Manuale utente

dji

dji PHANTOM 3 4K Manuale utente

Ares

Ares RECON FPV Manuale utente