2
**Platform for flooring is not included. We recommend using a 4 x 4 ft, 1/2" thick, piece of
plywood as flooring.
INSTRUCTIONS:
1) With wall panels A & B vertical, one person stands on the inside with nuts & the other on the
outside with the screws (8-32 x 3/4) (See Fig.1). Overlap the offset corner of Panel A with Panel
B. Using the predrilled holes, starting at the top insert screws (8-32 x 3/4) one at a time down the
edge of Panel B. DO NOT PUT A SCREW IN THE BOTTOM HOLE OF EACH PANEL
UNTIL FLOORING IS PLACED AT END OF ASSEMBLY. Make sure panels are tight
against each other before you insert each screw.
2) Repeat above steps on panels A & C. Now attach panel D (door panel)to panels B & C.
3) Place roof over the top of the panels. With one person inside and one out, insert screws (8-32
x 3/4) from the outside into predrilled holes along the bottom edge of roof panel. Again make
sure roof panel is tight against the wall panel before you insert each screw. Note: Some screw
holes may not line up. In the event this happens, re-drill holes from the outside of the roof
to line up with holes in the panels.
Floor Insertion:
4) When inserting flooring into your box blind, lay it on top of lip on inside of box blind bottom.
Insert 8-32 x 3/4" screws into the bottom predrilled hole on each panel corner.
***The next steps are for the use of 2 x 4's for extra support. If you choose not
to do this feature skip to step 8 to complete assembly of your box blind.
5) On the inside of the bow blind insert 2 x 4 #1 into the horizontal grove at the top just below
the roof on any side of the blind. Now insert 2 x 4 #2 beside it going horizontal in the same
groove in a different panel. Repeat these steps using another #2 and #3 to create a square at top
for reinforcement. Attach all lumber from outside of blind using 10 x 1 inch screws to fasten.
Now attach 2 x 4 #7 on opposite side of panel D to the grove on the edge of the bowed out
section of the panel going vertical running from the floor to the reinforced lumber up top.
6) Next go to the inside of the blind and insert the 2 x 4's #7 (that have been cut to 58 inches)
vertically into the groove that runs on the outside of the windows. Place the 2 x 4's on the two
walls that butt up against the wall with the door cut out. You don't need to put lumber on the wall
opposite of the door wall. All of the lumber will be screwed in from the outside of the blind
(going through plastic walls to the lumber).
