HX TDT001Z Manuale utente
此页不印刷
形式：骑马钉（24P）
尺寸：110x159mm
材质：120g双铜
工艺：单色 双面印刷，封面覆哑膜
ELECTRIC BICYCLE
User Manual
About the manual
-01-
1. Packing list
2. Function Introduction
3. Product assembly
4. How to ride
5. Safety note s
6. Battery instructions
7. Basic parameters
8. Daily maintenance
9. Warranty card
-02-
INDEX
Thank you for choosing our electric bicycle series products!
The safety instructions and precautions for electric bicycles are
introduced in the user manual, Please read it carefully for the first
using. If it is not used in accordance with the instructions in the
manual, it may cause danger, and the company will not bear any
responsibility for the personal injury or property loss caused by this!
For the safety of you and others, please read the manual carefully
before using to ensure that you can drive correctly and safely!
If you have any questions during use, or cannot get the information
from the manual, please contact your dealer in time!
3
4-5
6-8
9-11
12-16
17-18
19
20
21
Product function introduction
-03- -04-
*If anything is missing, please contact the dealer in time!
M5
M8
Packing list
1. The whole scooter
2. Accessories
Electric bike*1
Seat*1 Pedal*2 Charger*1 Wrench*2 User Manual*1
Chain*1 Left crank*1 Right crank*1 Crank screw*1 Plate holder*1
ELEC TRIC BI CYCLE
User Ma nual
Wheel
Rear wheel brakeFront wheel brake
Front lightFront light
Tube folding buckle
Pedal
Gearwheel
Frame
Seat adjustment wrench
Battery
Rear light
Rear shock absorber
Disc brake
Motor
Foot stand
seat
Headlight switch
Gear shift switch
Horn button
Display
Throttle
Key lock
-05- -06-
2
1 2 3
1.Lift the pole and the front of scooter, Fasten the folding buckle of pole.
2.Turn the fix ring of the folding buckle to fasten the spanner, prevent opening of folding buckle.
3.Align the handle bar of the scooter with the upper end of the pole, and lock the front with the
four screws provided.
1
3
Loose
Horn button: short press the button, the horn will "beep, beep".
Front and rear brakes: hold the brakes, the car will slow down and stop.
①
②
③
④
⑤
⑥
⑦
⑧
Function Description
Low speed mode: without D
Normal model: white D
High-speed mode: Red D
Note: When the brake is active, turning the throttle knob to accelerate is invalid!
Bluetooth
Battery power
Temperature alarm
Gear
Speed
Speed unit
Display content illustration
Product assembly
Display: battery power,speed,gear ect;
Key lock:Insert the key, turn clockwise to the ON position to turn on, and turn
counterclockwise to the OFF position to turn off;
Throttle:Move the throttle to ride in pure electric mode;
Headlight switch: push the switch to the ON position to turn on the front light,
push it to the OFF position to turn off the front light;
Photosensitive switch: When the ambient light becomes dark, the front and rear
lights will automatically turn on when the headlight switch is not turned on;
Gear shift switch: Toggle the switch to switch 1, 2, and 3 gears in sequence from
1. Open and fix the handle bar of the e-bike
Note: Shake the handlebar after installation, if it
becomes loose, pls adjust the screw as shown in the
figure. The screw cannot be adjusted too tightly. If it is
too tight, it will be difficult or impossible to open the
folding buckle wrench.
Tight
4.Install battery pack
5.Install the chain
6.Install the bike seat
-07- -08-
2. Install brake lever
3. Install pedal
Turn the brake lever up to be almost flush with the instrument, and use an
Allen key to tighten the screw.
Left
a. Install the crank without tooth disc on the left shaft of the scooter, and lock it clockwise with
the screws provided
b. Install the pedal marked with "L" on the left crank, and pay attention to the thread direction
of the pedal is counterclockwise assembly
Remove the battery
a. Install the crank with chainring on the shaft on the right side of the car, and lock it clockwise
with the equipped screw;
b. Install the pedal marked "R" on the right crank, and pay attention to the clockwise thread
direction of the pedal during installation;
Install the battery
Align the battery with the guide rail
and insert it, insert it to the end and
turn the key clockwise to lock it.
Remove the silicon cover, turn the
battery lock 90° anticlockwise and
pull the rope to take out the battery.
To install the chain, pass one end of the chain through the chainring and one end through the
flywheel of the motor, buckle the buckle into the chain, add a washer, and then clamp the circlip.
Note: It is better to tighten the chain and lock the buckle just to buckle both ends of the chain.
If it is too tight to buckle or too loose, the screw needs to be adjusted.
The adjustment method is as follows.
a. Use M19 wrenches to loosen the fixing screws on both sides of the motor;
b. Use an M10 wrench to adjust the tightness in the direction shown in the figure;
c. Just tighten the screws that fix the motor.
Loose Tight
Note: Pay attention to the safety line
when adjusting the height of the seat. The
safety line cannot exceed the saddle tube
to prevent danger!
Open the seat tube locking wrench, insert
the seat into the tube, adjust the height of
the seat and tighten the wrench.
Right
How to ride
-09- -10-
1. There is a risk of falling and injury during riding, so please wear
helmets, knee pads, elbow pads and other protective tools.
2. Adjust the seat to a height suitable for your comfortable riding
(appropriate height: when the foot is at the lowest point, the knee angle
is about 25 to 35 degrees, this height is the most suitable).
3. Insert the key, turn the key clockwise to the ON position to
turn on the E-bike and check the battery level.
4. Hold the brake tightly, straddle the bike with your right foot, step on the pedal
and sit down.
Note: When riding an electric bike for the first time, it is best to have
someone help stabilize the bike and keep the bike balanced.
5.Slowly release the brake and press the left foot lightly on the ground to
make the bike start to slide forward slowly. At the same time, use your right
foot to push forward forcefully. Step on the left foot pedal to start pedaling
alternately. Hold the handlebar firmly with both hands. Just like riding a
bicycle.
P
Safety notes
-11- -12-
7. loosen the throttle knob can slow down the speed, vigorously grip the brake handle
to do emergency brake.
Note:
1. When riding in rain and snow, the braking distance will be extended, so
please pay attention to slow down;
2.Use the rear brake during normal driving, and the front and rear brakes
should be used together for emergency braking. Do not use the front brake
for emergency braking during high-speed driving, as the front brake at high
speed may cause the danger of rolling over!
1. Please follow the traffic laws and regulations when using electric bikes.
It is forbidden to ride electric bikes into the motorway
2. Electric bikes should not be parked in the building foyer, evacuation corridor
or safety exit
3. It is prohibited to ride on the road with severe water accumulation.
The road condition of the water accumulation is unknown, which
may easily cause danger.
Note: when used for the first time, the throttle should be slowly turned to
speed up, to prevent the acceleration caused by too fast then out of control!
This electric bicycle provides three cycling modes (fitness mode, electric power mode
and electric mode).
Fitness mode: When the motor power is turned off, full-time manual cycling can reach
the goal of fitness just like riding an ordinary bicycle;
Electric power mode: Turning on the motor power, and the electric bike control system
will automatically output an electric power according to the intensity of pedaling during
cycling, making the riding very easy. Meanwhile, the riding distance can reach the
maximum range.
Electric mode: Switch on the motor power and turn the throttle handle to ride in electric
mode. There is no need for manual pedaling mode, which can save energy and ease
riding.
6.
a.
b.
c.
＞100
kg
＜16 ＞60
4. Do not ride Electric bicycles after drink.
5. Pregnant women and users under the age of 16 or over 60 are prohibited
to ride.
6. The maximum load of electric bikes is 100kg.
-13- -14-
7. It is prohibited to ride electric bicycles up and down stairs or jumping
obstacles.
8. It is forbidden for multiple people to ride the same electric bicycle at the
same time or ride with children in their arms.
9. It is forbidden to leave the handlebar with both hands while riding.
-15- -16-
13. Before riding an electric bicycle, please check the body and tires carefully
to ensure that there are no signs of looseness or damage.
14. When riding, braking, please observe the intersection to avoid
unnecessary damage to yourself or surrounding objects, people
and small animals.
15. Please turn off the electric lock when walking with Electic bicycle
prevent accidental acceleration of the throttle.
10. It is forbidden to modify the electric bicycle by yourself. It may cause
unstable operation of the electronic system and cause danger when riding.
11. It is forbidden to modify the battery of an electric bicycle without
permission. Modification of the battery is dangerous, and improper
operation may cause the battery to explode or catch fire.
12. Please try to avoid riding in rain or snow. If you need to ride, slow down
and avoid emergency braking.
Turn off the electric lock
Recommended tire pressure
240 Kpa-310 Kpa
Indice
Altri manuali HX Bicicletta
