CLEANING & CARE:
IT IS STRONGLY RECOMMENDED TO CLEAN THE ICE MAKER THOROUGHLY BEFORE
USING!
1. Remove the ice basket.
2. Unplug the water drain stopper to drain out leftover water.
3. Clean the exterior and interior of the ice maker regularly with a diluted solution of water and
vinegar. Do not spray the unit with chemicals and diluted agents such as acids, gasoline or oil.
Rinse thoroughly.
4. Dry the interior and exterior thoroughly before reassembling the unit.
5. When the appliance is not in use, unplug the water stopper to drain all water as mould can form
if moisture is trapped inside of the unit.
6. If the ice maker is reused after a long period of time, the water pump may not pump sufficient
amount of water and the water indicator will turn on. Reset the ice maker by pressing ON/OFF
button.
NOTE: If the compressor stops for any reason (e.g. water shortage, excess of ice etc.), use
the ON/OFF button to restart the system. Always wait 3 minutes before turning the machine
back on.
TROOUBLESHOOTING:
Please note, if power failure occurs or the ON/OFF button has been pressed accidentally during a
cycle, small ice chips may form and lodge in the automatic shovel causing jamming. Please
disconnect the machine from power source, gently push the shovel to the rear of the cabinet, and
remove ice chips. Make sure the water tray is horizontal and balanced. Then restart the machine.
PROBLEM POSSIBLE CAUSE SOLUTION
The compressor works
abnormally with a buzzing noise The voltage is lower than
recommended Stop the unit and do not restart
until voltage is normal.
“Add Water” indicator light is on 1. Water is low
2. There is air stuck in the pump 1. Press the ON/OFF button,
refill the tank and wait 3 minutes
before restarting the machine.
When water reached the fill line,
the ice maker will restart
automatically.
2. Remove the silicone water
stopper and let several drops of
water run out.
Indicator lights on the display are
not on Blown fuse/no power Replace fuse/turn power on
The ice cubes made are too
large and stuck together 1. Ice from previous cycles is left
in the water tray
2. The evaporator is too low
1. Stop the unit, wait for all the
ice to melt down and restart the
unit.
2. Shift evaporator a little
Conditions for ice making are
right but no ice is being made 1. There is no refrigerant in the
compressor
2. Compressor is broken/Fan
motor is broken
Call for service
The “Add Water” and “Ice Full”
lights are on at the same time Water tray is blocked by ice
cubes. Clear the ice cubes under the ice
shovel, pull out the power plug
and then plug back in. Press the
ON/OFF button and allow a few
