Troubleshooting Tips:
No lights:
If you see any messages on your laptop regarding a USB port:
Some laptops do not fully supply the specified 500ma continuous current rating. Please try
a different port or check with your laptop’s manufacturer to see if the USB ports are to
spec. In normal operation, you won’t see any popup message about the USB port or the
LANTAP kit.
Make sure the black USB cable is plugged in to your laptop and the black
box:
The LANTAP kit is USB powered and requires this cable be plugged in to function.
Is the Network cable plugged in to your laptop and the black box?
The yellow network cable is necessary for the LANTAP kit to communicate with your
laptop.
Make sure that your laptops network connection is enabled.
In Windows XP, open the Control Panel and then open Network Connections. Make sure
your laptop’s built in network port is enabled (Usually labeled Local Area Connection)
Connection Failed:
Have you set an IP address on your laptop's network interface?
Please make sure that you have set the correct IP address and subnet mask on your
laptop’s network port. If you don’t know what IP address to use, we suggest the following:
IP Address: 192.168.192.7 Subnet Mask: 255.255.0.0
Cessna Customer Service recommends the IP address be set to:
192.168.200.196 or 192.168.200.197
Do you have an older PCMCIA style network card installed in your laptop?
These will normally interfere with the operation of the new LANTAP kit and must be
completely disabled or removed.
Is the COAX cable plugged in properly?
The COAX cable should plug in to the aircraft on one end and the TEE connector with the
Terminator included with the kit on the other exactly as shown on page 2 of this booklet.
Instructions for setting your IP Address:
http://www.icsaero.com/products/groundtest/lantap-10/lt10-quickstart-xp
Please check for further info at: http://www.icsaero.com
For further support or for any questions, please contact us at:
Phone support is available Monday through Friday 8:00 A.M. to 4:00 P.M
