IKEA RODRET Manuale utente
RODRET
E2201
TRÅDFRI
LED2103G5
max 5 cm
(max 2")
> 10 s
13
2
4
English
RODRET wireless dimmer/power switch
works with smart lights and plugs from
IKEA. It can be used with DIRIGERA hub
to control smart products via the IKEA
Home smart app.
IKEA Home smart app
For Apple devices, download
the app using the App Store.
For Android devices, download
the app using Google Play
store.
Note: If you have a TRÅDFRI gateway
please use IKEA Home smart 1 app.
Getting started with DIRIGERA hub
Download the IKEA Home smart app
and follow the instructions on screen
to add the dimmer/switch to your IKEA
Home smart system.
Getting started without
DIRIGERA hub
1. Make sure the smart product you
want to connect is installed
and powered on.
5
2. Hold your dimmer/switch close to the
smart product (less than 5 cm away).
3. Press and hold the pairing button
for at least 10 seconds. A red LED
will show on the dimmer/switch. The
smart product will pulse with a white
LED once connected.
Good to know
Without DIRIGERA, you can connect a
maximum of 10 smart products to one
dimmer/switch. Remember to add one
product at a time. If your products are
close together, disconnect the ones you
have already connected while adding
the next product.
CAUTION:
DO NOT USE WITH STANDARD
DIMMERS. Only use the control
provided with or specied by these
instructions to control this bulb. This
bulb will not operate properly when
connected to a standard (incandescent)
dimmer or dimming control. Only
controllable by IKEA Smart lighting
products.
6
Get to know your product
Pairing button
Press to turn on, or long-press to
increase brightness
Press to turn o, or long-press to
decrease brightness
Changing the battery
A red LED light will blink when you
press any button the dimmer/switch
to show that a new battery is needed.
Open the battery lid and replace with a
new AAA/HR03 battery. We recommend
using a LADDA rechargeable battery.
Please note it is sold separately.
Factory reset
To reset and remove all connected
products, quick-press the pairing
button 4 times (within 5 seconds).
Follow steps 1-3 to reconnect your
smart products.
Care instructions
To clean the product, wipe it with
7
a soft cloth moistened with a little
mild detergent. Use another soft, dry
cloth to wipe dry. Never use abrasive
cleaners or chemical solvents as this
can damage the product.
IMPORTANT!
• The wireless dimmer is for indoor use
only and can be used in temperatures
ranging from 32º F to 104º F.
• Do not leave the wireless dimmer
in direct sunlight or near any heat
source, as it may overheat.
• Dierent building materials and
placement of the units can aect the
wireless connectivity range.
WARNING!
Risk of explosion if battery is replaced
by an incorrect type. Dispose of used
batteries according to the instructions.
8
Technical data
Model: RODRET wireless dimmer
Type: E2201
Input: 1.2 V, 1x AAA/HR03 LADDA
battery
Range: 10 m in open air.
For indoor use only
Operating frequency: 2405-2480 MHz
Output power: 3 dBm
IP-class: IP44
Type: LED2103G5
Operating frequency: 2405 – 2480MHz
Output power: 10 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult,
SWEDEN
This device complies with Part 15 of the
FCC Rules.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation Science and Economic
Development Canada's licence-exempt
RSS standard(s).
Operation is subject to the following
two conditions:
9
(1) this device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation of the device.
WARNING:
Any changes or modications to this
unit not expressly approved by the
party responsible for compliance could
void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
10
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the quipment o and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
RF EXPOSURE INFORMATION
This product is approved as a portable
handheld device (not body worn)
This product includes a static magnet,
generating a magnetic eld that might
interfere with the normal operation
of pacemakers, debrillators, or other
medical devices.
Altri manuali per RODRET
3
Questo manuale è adatto per i seguenti modelli
3
Indice
Lingue:
Altri manuali IKEA Attrezzatura di illuminazione
IKEA
IKEA ANSLUTA Manuale utente
IKEA
IKEA VATTENSTEN Manuale utente
IKEA
IKEA Sunnan Manuale utente
IKEA
IKEA Strala Manuale utente
IKEA
IKEA KORNSNO Manuale utente
IKEA
IKEA SKYDRAG L1903 Manuale utente
IKEA
IKEA SPANNLAND Manuale utente
IKEA
IKEA AKTERPORT Manuale utente
IKEA
IKEA OSTANA Manuale utente
IKEA
IKEA BLOTSNO 404.211.45 Manuale utente
IKEA
IKEA ANSLUTA Manuale utente
IKEA
IKEA MITTLED L1911 Manuale utente
IKEA
IKEA BETTORP Manuale utente
IKEA
IKEA ALANG Manuale utente
IKEA
IKEA LEDFYR Manuale utente
IKEA
IKEA SEGLATS Manuale utente
IKEA
IKEA ROLFSTORP Manuale utente
IKEA
IKEA NAVLINGE Manuale utente
IKEA
IKEA TÄRNABY Manuale utente
IKEA
IKEA STRALA J1938 Manuale utente
