IKEA FOLKVANLIG Manuale utente
FOLKVÄNLIG
Design and Quality
IKEA of Sweden
ENGLISH 4
DEUTSCH 19
FRANÇAIS 34
NEDERLANDS 49
ÍSLENSKA 64
NORSK 79
SUOMI 94
SVENSKA 109
ESPAÑOL 124
PORTUGUÊS 139
4
TABLE OF CONTENTS
1. IMPORTANT INFORMATION BEFORE YOU START BIKING 5
2. INTRODUCTION 6
3. INSPECTION AND SETTINGS BEFORE YOU START RIDING 7
4. YOUR FIRST RIDE 8
5. USING YOUR E-BIKE 9
6. BATTERY CHARGING INSTRUCTION 13
7. SAFETY INSTRUCTIONS FOR THE BATTERY AND CHARGER 14
8. TECHNICAL SPECIFICATIONS 15
9. CONTROLS SETTINGS 16
10. MAINTENANCE 17
OPERATING INSTRUCTIONS FOR ELECTRIC BIKES
5
• Before your rst ride, please read the operating instructions
carefully and check that all parts are in good condition.
• Please slow down in slippery conditions, e.g. in rain or snow,
and consider that you will need greater braking distances to
guarantee stopping safely.
• This e-bike works reliably under all weather conditions
although excessive water exposure could damage the
electronics and/or the electric motor.
• Never touch the electronics on the e-bike with wet hands and
never touch the plus and minus poles at the same time, as
the strong short-circuit current could cause injury.
• Never attempt to repair electronics on the e-bike yourself,
always ask a specialist retailer.
• The battery performance can vary depending on the
temperature. Temperatures below 0°C will decrease the
distance you can ride the e-bike without recharging. The
battery performs the best in temperatures above 0°C.
1. IMPORTANT INFORMATION BEFORE YOU START BIKING
6
Frame material: Aluminum
Wheel size: 29"
Front fork: Steel with Suspension
Gears: 21 speed
Rims: Double-wall alloy
Brakes: Disc brakes
Motor: 36 Volts - 250 Watts
Assembly: 95 % (stem turned)
Gross weight: 30 kg.
Net weight of bicycle: 28 kg including
battery.
Battery weight: 1.90 kg
Battery dimensions: 170x100x80 mm
Battery power: 36V 8,7AH
Max load of the bike: 120 kg
2. INTRODUCTION
18
10
3
2
19
17
16
32
30
33
4
21
23
24
39
25
37 22
35
34
27
15
40
41 13
7
8
6
1
36
14
29
4
38
26
5
31
9
44
11
12
20 42
43
1) Frame
2) Fork-
3) Seat post
4) Mudguard
5) Kick stand
6) Head set
7) Handle bar
8) Adjustable stem
9) Grip
10) Saddle
11) F.Disc brake
12) R.Disc brake
13) Brake lever
14) F.Derailleur
15) R.Derailleur
16) Shift lever
17) Bb parts (bottom bracket)
18) Chain wheel&crank
19) Chain
20) Pedal
21) Battery
22) Charger
23) Display
24) Sensor
25) Controller
26) Integrated line
27) Engine
28) Rim
29) Spoke
30) Tire
31) Inner tube
32) Rim tape
33) Front hub
34) Freewheel
35) Quick release
36) Front light
37) Rear light
38) Bell
39) Reector
40) Brake line
41) Derailleur line
42) Screws
43) Tool set
44) Crank cover
7
3. INSPECTION AND SETTINGS BEFORE YOU START RIDING
Tighten the screws:
8
4. YOUR FIRST RIDE
• Be very careful the rst time you ride your e-bike! In power
mode, the e-bike is considerably faster than a normal bike!
• Take your rst ride on open land so you can get used to the
improved acceleration.
• The control unit has a low-voltage protection system which
automatically switches off the power assist if the battery
voltage falls below a certain level.
• Be careful when braking. Always brake with the rear wheel
brake rst, it is less aggressive than the front wheel brake.
• The power assist is deactivated at 25 km/h. It is
automatically switched back on again once the speed drops
below 25 km/h.
• Do not use power assist on slippery surfaces and gravel.
• Switch power assist off if the e-bike is not behaving normally
to avoid damaging electrical components.
9
• Start pedalling; the electric motor will only assist you while
you are pedalling.
• If you wish to change the assist level, press the plus or minus
buttons.
• The power assists stops when you use the brakes.
• The power assists stops when you reach 25km/h.
• If you leave the e-bike unattended, lock the battery with the
key, or take the battery with you.
To start the battery, use the ON button.
Control panel:
The engine is controlled by the control panel on the handle bar.
There are six different speed levels. To reach optimal function
you should chose a low speed on the control panel and set the
gear switch in level 1 when you start pedalling.
ON/OFF:
Push and keep the ON/OFF button pressed for about 2 seconds.
The LCD display lights up. To shut the display down manually,
press the ON/OFF button for 2 seconds.
1. To start the display, use the ON/OFF button.
2. Keep the plus button down for a couple of second to turn on
the display light. Do the same thing to turn OFF the display
light.
3. The assistance levels are changed with the plus and minus
buttons. There are 6 levels available.
4. If you need support with leading your e-bike, keep the
minus button pressed down and your e-bike will reach 6
km/h.
5. USING YOUR E-BIKE
10
RANGE OVERVIEW
Condition: Battery is fully charged and new (313Wh, 36V, 8.7Ah)
Driver approximately 74 kg
Distance
Road conditions 10 km 20 km 30 km 40 km 50 km 60 km 70 km
Flat roads Light tailwind
28 degrees Celsius
Dry roads
Slightly hilly terrain Light tailwind
28 degrees Celsius
Dry roads
Strong hilly terrain Light tailwind
28 degrees Celsius
Dry roads
Medium assist - maximum help from own pedalling
Medium assist - low to medium help from own pedalling
Maximum assist - maximum help from own pedalling
Maximum assist - low to medium help from own pedalling
Indice
Lingue:
