
i
KK
–
UHF Wireless Microphone – IK-WM01
i
kk
BATTERY STATUS:
a) Light Status: The transmitter and Receiver are built-in, with re-chargeable
polymer battery.
b) These products can be charged by any Computer USB port or Mobile AC
adapter USB charging, connecting by USB /Micro USB cable.
c) When the Blue Light flashes or goes out, or turning to Red Light, its mean that
the battery power is insufficient, so it requires to be charge both devices
Transmitter/ Receiver at same time.
d) After charging is completed, the Red light will turn off.
PAIRING DEVICES:
Transmitter (Tx) and Receiver (Rx).
Normally the units will be factory default, it means pairing AUTOMATICALLY when
turned ON. If it doesn’t happen please follow the procedures below.
Note:
- The Receiver has a 1 Blue light to indicate unit “ON” mode and 1 Red light to
indicate that Transmitter and Receiver are connected it mean “Paired”.
- The Transmitter has 2 Blue Light, one light to indicate ON mode, and 1 light to
indicate Pairing procedures when it needs to be in pairing mode procedure.
Pairing procedure:
Turn the Transmitter ON (Tx)
Press and Hold per 1 second “Up” or
Confirm if Tx blue light is ON
“Down” key, to confirm the Step.
Press and Hold the Vol.keys Up/Down at
Now Turn OFF both Rx/Tx units, and
same time, until Tx blue light get flashes
Turn ON again Rx and Tx, will be seen
Rx Red and Blue light “ON” by Tx unit ON.
Turn the Receiver ON (Rx)
Its mean that units are paired successfully!
Confirm if Rx Red light get 3 flashes
If your connection problem persists
and Stopped flash, that indicates Tx and Rx
Please repeat the procedure.
Or make sure the battery are charged
Change Frequency:
If your environment produce interference that can affect your device performance, you
can try to reduce interference by changing the frequency, following the below Step.
At Tx, press and hold per 2 second the key “Up or Down”, pay attention that both
units the lights will flashes, its indicates that frequency is changing in booth units.
Release the key and the frequency will stop and keeping automatically paired in
If your problem persists, please repeat the procedure to get another frequency