ILS S1839 Manuale utente
A. Metal pins
B. Screws
C. Hanging clips
D. Large T shaped bar
E. Small T shaped bar
F. Small extension bars
G. Large extension bar
H. L shaped bar
A
D
E
FGHIncluded in the Box
Assembly Guide
Seat Walker Holder – Scooter Accessory
S1839 - Scooter Accessory - Seat Walker Holder for Scooters (ILS ADL)
©2023 Independent Living Specialists, Unit 1, 12 Mars Road Lane Cove West NSW 2066 | 1300 008 267 | ilsau.com.au
Place L shaped bar in rear receiver of
scooter and place metal pin and/or
screw in position.
Slide the small T shaped bar to the very
bottom of the L shaped bar and tighten
screw into position.
Place the small T shaped bar through
the L shaped bar.
Place small extension bars at both ends
of the T shaped bar and tighten with
screws.
B
C
PDT030-0323
Install long extension tube onto the top
with screw and metal pin.
left and right side, facing outwards at
the end of the small T shaped bar.
Lift and place seat walker on the holder
to check prior to purchasing).
Place this T bar on top of the long
extension tube and insert screw.
See fully assembled seat walker holder.
Secure tightly to the holder with Velcro
straps provided.
Assembly Guide
Seat Walker Holder – Scooter Accessory
S1839 - Scooter Accessory - Seat Walker Holder for Scooters (ILS ADL)
©2023 Independent Living Specialists, Unit 1, 12 Mars Road Lane Cove West NSW 2066 | 1300 008 267 | ilsau.com.au
PDT030-0323
Altri manuali ILS Scooter
