5: “Stop”function: Stops the device immediately, regardless of the current chart
position.
“Reset” function: Resets the device in case of an error and turns off “Error” LED.
“Profile” function: iQ-Near Focus has two modes of movement.
1. Starting at the top position: Quickly move down to clear the camera's FOV,
stay down for the set duration and then slowly move back up.
2. Starting at the bottom position: Quickly move up into the camera’s FOV, stay
there for the set duration and then slowly move down to the starting position.
To switch between these modes, hold down the “Stop/Reset, Profile” button. The
display will show “P1” or “P2”. Switch profiles by pressing the “+” or “-“ button. When
releasing the “Stop/Reset, Profile” button, the display will automatically show the set
delay again.
6: “Start” Button: Starts the device using the previously set parameters.
7, 8: “+/-“ Buttons: increase/decrease the delay between movements steps of whole
seconds. These buttons are also used to cycle through movement modes (see label 5,
“Profile” function.
9: Start “manually” (2,5mm TRS jack socket): Typically used to connect a standard
remote shutter release.
10: Start “LED-Panel” (3,5mm TRS jack socket): This socket is used to connect the iQ-
Near Focus to the LED Panel in order to start both devices simultaneously with a
remote shutter release.
3.2 Height adjustment of frame
The upper part of the frame is height adjustable. The
center of the chart resting in its upper position can be
set to a height between 132cm and 165cm.
We recommend changing the height with the help of
another person.
- Secure the upper frame with one hand on either
side.
- Loosen the highlighted handles by turning them
counter clockwise
- Lift or lower the frame to the desired height
- Tighten the handles down again firmly to prevent
the frame from dropping on its own.
WARNING: Risk of pinching!
Figure 6: Height adjustment of iQ-Near Focus
