6
iv. Start the InnoBASIC™Workshop
v. Click the “Tools” item in the menu bar on the top.
vi. Click the “Motion Editor” in the pull-down menu (If a warning window appears, it
means that the BASIC Commander®is not correctly connected. Please check if the
USB cable is connected or unplug and then plug it again to ensure a correct
connection. Exit the Motion Editor and then re-click this button.)
vii. If the connection is correct, the message “Downloading servo manager...” will be
displayed on the PC screen meaning that the program is being downloaded. Please
poke the DIPswitch on the Command Board to the 1 position and wait a moment.
viii. After the downloading is complete, a notification window will appear. Please make
sure that each servo has been connected correctly. After confirming all the
connections, please click “OK”. (If “Cancel” is clicked, the Motion Editor will be
closed. If there is any component is incorrectly connected at this moment, please
click “Cancel” to terminate the program.)
Click the application in the InnoBASIC™Workshop
folder to start the InnoBASIC™Workshop.
After clicking each item, a pull-down menu with
more function items will be displayed. Please click
the “Tools" item now.
Click “Motion Editor” to start the Motion Editor.
If this message appears, it means that the USB
cable is not connected correctly.
The message means that the program is being
