INPRO EverWhite Manuale utente
Installation Questions?
Contact our Installation Hotline 866.EZINPRO
For Sales & Customer Service call 800.222.5556
MOUNTING CLIP
FIG. 1
Installation Instructions
EverWhite Framed Dry Erase Boards
IPC.464/REV.1
MOUNTING CLIP
#10 x 11/4"
SHEET METAL SCREWS
FIG. 2
Please read all instructions before installing dry erase
board. Material must be stored, installed and used in
environmentally controlled conditions.
Install EverWhite dry erase boards level and plumb and
at the height indicated on shop drawings.
Installation with mounting clips.
1. Snap a level chalk line at the required height of the chalk
tray. Using a mounting clip as a template, align the bend of
the clip on the chalk line and mark the top of the slot in the
mounting clip on the wall. See Figure 1.
2. Drill a 1/4" hole at each location and pound the included
anchors flush with the wall surface. Attach the bottom clips to
the wall with the #10 x 1-1/4" sheet metal screws making sure
all clips are level. See Figure 2.
3. Place the marker board on the bottom clips and move the
sides of the board into the required position. Mark the sides
and the top of the board. Remove the marker board from the
bottom clips. See Figure 3.
LOCATION OF
DRY ERASE BOARD
FIG. 3
Installation Questions?
Contact our Installation Hotline 866.EZINPRO
For Sales & Customer Service call 800.222.5556
Installation Instructions
EverWhite Framed Dry Erase Boards
MOUNTING CLIP
#10 x 11/4"
SHEET METAL SCREWS
FIG. 4 4. Drill 1/4" holes 1" in from top and side edge marks.
Hammer the anchors into these holes, flush to the surface.
Attach the remaining clips outside the marks and tighten
them. See Figure 4.
5. Apply six 3" circles of construction adhesive on the back of
an 8' board and ten 3" circles on the back of a 12' board. Lift
the board onto the lower clips. Hammer the side and top clips
tight against the frame. Using #10 x 3/4" self-tapping screws
attach the clips to the board. Install the side clips first,
followed by the bottom clips and complete the installation by
fastening the top clips. See Figure 5.
MOUNTING CLIP
#10 x 3/4"
SHEET METAL SCREWS
DRY ERASE BOARD
FIG. 5
Indice
Altri manuali INPRO Accessori
