Please read all instructions before installing
wallguard.
STAINLESS STEEL
WALL GUARD
LEFT RETURN
1/4-20 x 6"
PHILLIPS FLAT HEAD SCREW
(OR APPROPRIATE FASTENER)
51SS
GASKET
51SS
BRACKET
TOGGLE
FIG. 3
CHALK LINE
FIG. 2
1. Layout the wall guard sections in the installation area.
SEE FIG. 1
2. Determine the height of the wall guard. Snap a chalk
line:
51SS - 2” [51mm] below that height
56SSF - 3”[76mm] below that height
The chalk line is the centerline of the fasteners.
3. Use the wall guard as a template to mark the mounting
hole locations. If inside and outside corners are part
of the installation allow 3-1/8” [80mm] for the bracket
and gasket depth when positioning the wall guard. The
distance from the wall to the back of the wall guard is
3-1/8” [80mm].
Drill marked holes with 3/4" drill bit for toggle bolts
(drywall installation) or 1/2" drill bit for lead anchor
(concrete wall installation). Mount brackets to wall,
tighten screws to secure.
SEE FIG. 2
4. Loosely attach the wall guard, gasket, mounting
bracket and appropriate fasteners at each mounting
location. When the installation involves longer lengths
or is a continuous installation with corners, a single
bracket is used at the butt joint.
SEE FIG. 3
STAINLESS STEEL
WALL GUARD
OUTSIDE
CORNER
INSIDE
CORNER
RIGHT
RETURN
LEFT RETURN
1/4-20 x 6"
PHILLIPS FLAT HEAD SCREW
(OR APPROPRIATE FASTENER)
51SS
GASKET
51SS
BRACKET
TOGGLE
FIG. 1
Installation Instructions
51SS and 56SSF Stainless Steel Wall Guards
