Wiring Instructions (Fig 5.)
1. Connectionsshownaretypicalfor1-10Vdimmableandnon-dimmablebattenssuppliedbyIntegral.
2. ****Supply-WiringcoloursshouldbeEuropeanBrownliveandBlueNeutralmustmakeanotethatsensor
cabledshouldbesleevedwiththeappropriatecolourforinstallation***
3. The black and white sensor wires should be appropriately sleeved with brown (Live) and blue (neutral)
sleeving during installation.
Operation using hand controller (Fig 6.)
1. To use the hand controller to program luminaires, point the hand controller at the installed PIR sensor
receiver (under the domed PIR sensor lens).
2. NOTE: Step down lighting and dimming options are only available with products with 1-10V Dimming
enableddrivers.
3. ON/OFF MODE BUTTON:ToggletheLAMPcontinuallyon/o.
4. RESET MODE BUTTON:(ONE-TOUCHMODE)
Defaultsettings:
5. AUTO MODE BUTTON:PressingAutomodebuttonenablesthesensorwiththelast-programmedparameters
beforeeitherON/OFF,RESETorMmodebuttonswerepressed.
6. NotethattheparameterscanstillbeadjustedinAUTOMODE.
7. AUTO MODE SETTINGS PROGRAMMING EXAMPLE:Settheparametersfor:sensitivity50%,holdtime10
seconds,lux,dimminglevel20%,dimmingtime1min.
a) STEP:presstheautobutton. LEDwillashoncetoconrm.
b) STEP:pressthesensitivitybutton50%. LEDwillashoncetoconrm.
c) STEP:pressholdtime10sbuttons. LEDwillashoncetoconrm.
d) STEP:pressluxbutton. LEDwillashoncetoconrm.
e) STEP:pressdimminglevelbutton20%. LEDwillashoncetoconrm.
f) STEP:dimmingtime1minbutton. LEDwillashoncetoconrm.
8. To check settings, move across sensor to make the LAMP turn on with 100% brightness. After 10s with
nomovementtheLAMPshouldgofrom100%to20%brightness.
ToggleLAMP
continuallyon/o
Initiate a 2 second sensor test
Standbyanddaylightsensor
aredisabledduringthetest.
Store/setparameters
inmemory
EnableAUTOMODEusing
latest stored settings
Aonetouchbutton.
Defaultsettingsare:
100%motionsensitivity
10 second hold time
20%standbylightlevel
24hourstandby-nevero
Setmotiondetectionsensitivity Set the hold time during which
triggering is ignored. Refers to the
timeperiodthelampremainsat100%
illumination after no motion detected.
Use this to override
previous lux setting. This
allowsdaylightthreshold
tobesetforprevailing
light conditions
Usethesebuttonstosetthedaylight
threshold 10lux, 30lux, 50lux or
fordaylightsensordisabled
Setthelightleveloutputforstandby,
Referstothelowlightlevelyouwould
liketohaveaftertheholdtimeinthe
absenceofpeople
Setthestandbyperiod.
24hourisnevero.
Refers to the time period
the lamp remains at a
lowlightlevelbeforeit
completelyswitchesoin
theabsenceofpeople.
