Operating controls specifications
Button
If pressed for longer than 10 seconds the repeater is reset to the original
state (disconnected device).
This action causes the loss of data relating to the network radio
communication and the loss of connection with the Remote Display and
all devices connected to it.
Solid light of all the
LEDs with a brief
flash every 20
seconds.
Indicates that the transmitter is
not connected to any radio
network.
Slow flashing indicates that the
transmitter is operating normally.
Quick flashing indicates that the
network is open and therefore
allows the association of new
devices.
The flashing indicates the device
is connected via radio to the
Remote Display
The number of flashes indicates
the number of connected devices
with strong radio signal.
Install the device in proper position and turn it on.
When you first switch on the device, verify that it is not attached to any
radio network (the LEDs are all switched on and perform a quick flash for
two seconds every 20 seconds), otherwise disconnect the device by
pressing the button for more than 10 seconds.
Acting on the Remote Display, open the radio network (menu/Radio
Management/ Open Radio Network) following these steps:
A few seconds after opening the network, the repeater should connect to
the radio network of the remote display. The operation's success is
evidenced by the flashing of led LD1 of the device.
If the Repeater is still disconnected after 30 seconds of the network
opening, probably the location chosen for the device is not suitable; in that
case bring the repeater closer to the remote display or to another repeater.
When finished, close the radio network by In-house Display.
Association to the In-house Display (network Joining)
Regulations: 2006/95/CE, 89/336/CE, 99/5/CE
Standards: EN 300 328, EN 301 489,
EN 61000-6-2, EN 6100-6-3,EN 60950-1
In case of disposal, the products must be disposed of separately in
accordance with applicable local laws.
The warranty period is 2 years from the date of installation or 30 months
from the date of manufacture.
The warranty applies only in UK.
The manufacturer agrees to replace or repair the components that are
found defective.
Damage caused by improper installation, by a power supply not
compliant with the CEI EN 50160 standard, by the incorrect use or
failure to comply with the instructions contained in the Assembling
Installation is not covered by the warranty.
Confirm this request to open
the In-house Display radio
network.
At the end of the
association, confirm this
request to close the In-
house Display's radio
network.
Press the button under
"Menu".
Select the "Radio
Management" menu
Select "Open Radio
Network"
4-noks s.r.l. –Francenigo di Gaiarine (TV) - Italy
