Intimus PB-250 Manuale utente
Comb Binding Machine
PB-250
GB
95495 1 12/18
CAPABILITIES
Technical Data
Width : 300mm
Punching Thickness : 25 sheets
Punch PVC Cover : 2 Sheets
Punch PP Cover : 1 Sheet
Machine Dimension :
Weight :
Binding Thickness : 500sheets
Pitch : 14.25mm
Disengagement Punch Pins:
Comb
Comb
Comb
Comb Size
Size
Size
Size Selector
Selector
Selector
Selector
21
49.7x28.8x44.1CM
11Kgs
ENGLISH
P/01
Punching Level
Comb
Comb holder
Binding level
21 Disengagement
punch pins
Punching margin controller
Side Margin Controller
Paper entrance
Base board
IMPORTANT SAFETY INSTRUCTIONS-KEEP FOR
FUTURE USE
When punching;
- always ensure the machine is on a stable surface
- test punch scrap sheets and set the machine before punching final
documents
- remove staples and other metal articles prior to punching
- never exceed the machines quoted performance
Keep the machine away from heat and water sources.
Never attempt to open or otherwise repair the machine.
SET UP
1.Ensure the machine is on a
stable surface.
Please read before use and keep for
future
P/02
2.Check the waste tray is empty
and correctly fitted.
3.Ensure the comb opening lever is
pushed backwards.
SET UP
BEFORE YOU BIND
1.Select the correct punch profile for the sheet size
select releasable dies as appropriate
2.To cancel a punch, pull the pin forward.
3.Select the correct back margin
depth for the number of sheets
P/03
BEFORE YOU BIND
4.Test punch scrap sheets to check edge
guide setting.after according to your file's
size to select the paper position.then insert
files and push the handle down and then
release it to it's original place
5.Place the plastic rings to the back
of comb opening upwards.push the
binding handle frontwards to open
the plastic rings
6.Load punched sheets directly onto the
open comb
7.When all punched sheets are loaded onto
the comb,push the comb level backwards to
close the comb and remove the bound documents.
P/04
REMOVAL OF WASTE CLIPPINGS
TROUBLESHOOTING
Problem
Problem
Problem
Problem Cause
Cause
Cause
Cause Solution
Solution
Solution
Solution
The waste tray is located under the machine and is accessed from the front side. For best
results empty the tray regularly.
Punched holes are not central Edgeguide not
set
Adjust edge guide until hole pattern
is correct
Machine willnotpunch Blockage Check waste tray is empty.
Check for blockage
Punch holes are notparallel
to edge
Debris is stuck below dies Take stiff cardboard and slide into the
paper entry. Move the cardboard side-
ways to release any stray clippings
into the waste tray
Partial holes Sheets not correctly aligned
to punch pattern
Adjust edge guide and test punch
scrap sheets until correct
Damagedhole edges Possibly overloading the
machine
Punch plastic covers with paper
sheets.Reduce number of sheets being
punched
P/05
Intimus International GmbH
Bergheimer Straße 6 - 12
88677 Markdorf / Germany
Tel.: ++49 (0)7544 / 60-0
Fax.: ++49 (0)7544 / 60-248
E-mail: [email protected]
www.intimus.com
95495 1 12/18
Indice
Altri manuali Intimus Macchina rilegatrice
